broadcom-diag is not supported any more and was replaced by
configuration the GPIOs in the arch code
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
SVN-Revision: 41047
Seems like the reverse order relies on GNU specific getopt hackery which
musl does not replicate
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
SVN-Revision: 41045
Without this patch, /etc/hotplug.d/tty/30-3g won't be called when you insert or remove a USB-serial cellular modem.
(see Ticket #14117)
Signed-off-by: Matthew Reeve <mreeve@tenxnetworks.com>
SVN-Revision: 41039
ubiblock allows creating and removing read-only block devices
on top of ubi volumes.
Signed-off-by: Daniel Golle <daniel@makrotopia.org>
SVN-Revision: 41033
today appeared another serious vulnerability in openssl. More info is
here http://ccsinjection.lepidum.co.jp. Users are advised to update to
openssl 1.0.1h.
Signed-off-by: Martin Strbacka <martin.strbacka@nic.cz>
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
SVN-Revision: 41026
Fixed wpa_supplicant when the radio is in 40MHz mode so that it no
longer restarts hostapd with the second channel disabled.
Signed-off-by: Lance Chaney <furryfur1@gmail.com>
SVN-Revision: 41019
rsn_preauth is used outside of "case $auth_type", so if it is set
for an EAP-enabled SSID, it would also be set for the following
non-EAP-enabled SSIDs, because it would not be read again.
Signed-off-by: Reiner Herrmann <reiner@reiner-h.de>
SVN-Revision: 41012
Allow to use "package", "type", "name", "error" and "result"
as config option names:
package some_service
config section 'foo'
option name 'bar'
option type 'unknown'
Signed-off-by: Maxim Storchak <m.storchak@gmail.com>
SVN-Revision: 41006
Let the first parameter of function config_get be local, because there
is a chance that config_get won't export the variable.
Signed-off-by: Zhao, Gang <gamerh2o@gmail.com>
SVN-Revision: 41000
Fix a build regression caused by r39975 by making sure $(STAGING_DIR)/host
directory exists before trying to copy files to it.
Cc: Florian Fainelli <florian@openwrt.org>
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
SVN-Revision: 40998
This resolves a module dependency kernel regression in r40905 with the
usb-chipidea module if usb-gadget was not selected.
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
SVN-Revision: 40992
In case of .11ac device the hwmode was not properly displayed.
This patch fixes it.
Signed-off-by: Marek Kwaczynski <marek.kwaczynski@tieto.com>
Signed-off-by: Bartosz Markowski <bartosz.markowski@tieto.com>
SVN-Revision: 40953
- The package does not compile at the moment. Since there is a new
upstream version avaiable, use this new source instead.
- Upstream has already included our both patches.
- This is only compile tested, since I do not own any test hardware.
Signed-off-by: Michael Heimpold <mhei@heimpold.de>
SVN-Revision: 40940
This patch enables netifd to query 802.11ac-driver for the maximum
supported A-MPDU length exponent, possibly increasing VHT throughput by
more aggressive frame aggregation.
v2: refreshed patch
Signed-off-by: Matti Laakso <malaakso at elisanet.fi>
SVN-Revision: 40938
It's quite unconveniet to remember which ports are used by which applications, especially for not so advanced users.
Together with luci patch (discussed on IRC) this improves qos-scripts usability.
Signed-off-by: Roman Yeryomin <roman@advem.lv>
SVN-Revision: 40935
`own_ip_addr` is used by hostapd as NAS-IP-Address.
This is used to identify the AP that is requesting the authentication of the
user and could be used to define which AP's can authenticate users.
Some vendors implement only NAS-Identifier or NAS-IP-Address and not both.
This patch adds ownip as an optional parameter in /etc/config/wireless.
Signed-off-by: Thomas Wouters <thomaswouters@gmail.com>
SVN-Revision: 40934
allows to set PPP interface name manually via new
network interface option pppname.
If not set, default naming will be used (e.g. pppoe-eth0)
Signed-off-by: Ulrich Weber <uw@ocedo.com>
SVN-Revision: 40933
kmod-hid-generic needs to be selected when enabling usb-hid in order to get generic devices working.
This fixes keyboards support in linux 3.3+ kernels.
https://dev.openwrt.org/ticket/12631https://dev.openwrt.org/ticket/12686
Signed-off-by: Álvaro Fernández Rojas <noltari@gmail.com>
SVN-Revision: 40932
The sulogin tool doesn't compile because it cannot find shadow.h. As the
tool is not available in openwrt it is now not selected during the build
process.
Signed-off-by: Tjalling Hattink <t.hattink@fugro.nl>
SVN-Revision: 40930
On UBI enabled devices, U-Boot might store it's environment on
UBI volume(s). Support this in uboot-envtools, so fw_setenv and
fw_printenv can work on these platforms.
Signed-off-by: Daniel Golle <daniel@makrotopia.org>
SVN-Revision: 40929
The find(1) -perm +mode is no longer supported and has been deprecated since
2005.
This could resolve#13855 ticket.
Signed-off-by: Rocco Folino <lordzen87@gmail.com>
SVN-Revision: 40927
This patch adds support for building the kernel modules for gadget serial devices.
Signed-off-by: Owen Kirby <osk@exegin.com>
Acked-by: Tim Harvey <tharvey@gateworks.com>
SVN-Revision: 40917
when disabling ipv6, the iptables build breaks without a manul clean or this patch
Signed-off-by: Bastian Bittorf <bittorf@bluebottle.com>
SVN-Revision: 40916
Since svn rev [38557] we support power buttons, for example
the ACPI power button on x86 machines.
Add a simple shutdown script to /etc/rc.button, to gracefully shutdown
the machine after the power button is pressed.
Tested on x86 and x86_64 in a kvm virtual machine.
Signed-off-by: Stefan Hellermann <stefan@the2masters.de>
SVN-Revision: 40909
Before this patch, doing `/e/c/network restart' will emit the folloing
error by `ubus network.wireless down "{}"' because netifd already quit
by that time.
Command failed: not found
Signed-off-by: Yousong Zhou <yszhou4tech@gmail.com>
SVN-Revision: 40906
The chipidea USB OTG controller is dual-role and supports both host and device
modes. Enable device mode.
Tested on Gateworks Ventana imx6 board with g_ether.
Are there any other targets out there that use the CHIPIDEA controller? If so
testing is needed for those.
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
SVN-Revision: 40905
Patch sets the source IP address of DHCP request messages during rebind to the IP address
assigned to the udhcpc client. Source address 0.0.0.0 can only be used by a client prior
to obtaining its IP address (see RFC2131 § 4.1). Source IP address behavior lines up now with
the ISC dhcp client implementation for DHCP request messages during rebind and DHCP release
messages.
Signed-off-by: Hans Dedecker <dedeckeh@gmail.com>
SVN-Revision: 40878
Many of the 4G/LTE and 3G modems utilize the QMI-protocol to control the
modem. At the moment there is no support for them in OpenWrt. This
patch adds support for them in the form of a netifd script and a
control utility. Tested with Huawei E398 and ZTE MF820D (which requires
a delay of ~30 s before responding to QMI commands). I put myself up as
the maintainer, feel free to change this if you desire.
Signed-off-by: Matti Laakso <malaakso@elisanet.fi>
SVN-Revision: 40868
The settings require that the OpenWrt provided u-boot is used as either
first or second stage bootloader as it modifies the partitioning scheme
to move the u-boot environment to a separate mtd partition.
Signed-off-by: Felix Kaechele <heffer@fedoraproject.org>
SVN-Revision: 40829
This patch modifies the u-boot config for the Pogoplug E02 to work with
OpenWrt. It also enables building a second stage bootloader image.
Signed-off-by: Felix Kaechele <heffer@fedoraproject.org>
SVN-Revision: 40828
DHCP entries in /etc/config/dhcp will not automatically create A or PTR
records. Add an "option dns" directive which appends an entry to
/tmp/hosts/dhcp to facilitate forward and reverse DNS lookups. For
instance, this item:
config host
option ip '192.168.0.10'
option mac '00:13:57:9b:df:02'
option name 'winpc'
option dns '1'
will add a corresponding entry to /tmp/hosts/dhcp:
192.168.0.10 winpc.lan
This keeps the hostname/IP/MAC in a single place, for easy maintenance.
Related: ticket #13854 reports an regression involving missing PTR
records when using "config domain" to define static DNS entries for
individual hosts. However, per Simon Kelley[1], the --address feature
used by "config domain" was never intended to generate DNS A records for
hosts. It would probably be better for the reporter to apply this patch,
and then use "config host" sections instead of "config domain" sections.
[1] http://lists.thekelleys.org.uk/pipermail/dnsmasq-discuss/2008q4/002498.html
Signed-off-by: Kevin Cernekee <cernekee@gmail.com>
Signed-off-by: Florian Fainelli <florian@openwrt.org>
SVN-Revision: 40799
Without this patch /dev/spidev*.* only appears if CONFIG_SPI_SPIDEV is manually
selected and set to "y" from the kernel config.
Signed-off-by: Álvaro Fernández Rojas <noltari@gmail.com>
Signed-off-by: Florian Fainelli <florian@openwrt.org>
SVN-Revision: 40784
This patch disables mips16 support in the ltq-hcd driver because some
people reported slow speed and problems with usb storage devices, 3G
dongles and wireless usb adapters.
Signed-off-by: José Vázquez Fernández <ppvazquezfer@gmail.com>
SVN-Revision: 40775
This allows services to bind to it at boot time instead of waiting for a
cable to be plugged in
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
SVN-Revision: 40773
When IGNORE_ERROR is set, also skip broken downloads, this is required
to make a full "make download" run even if some upstream sources are
unreachable.
Signed-off-by: Jo-Philipp Wich <jow@openwrt.org>
SVN-Revision: 40768
As both of the PKG_SOURCE_URLs within the Apex Makefile appear to be no
longer functional, this patch changes the source URL to the OpenWRT
downloads page. Apologies for resubmitting, but there was a syntax error
in the previous patch ( http://patchwork.openwrt.org/patch/5025 ).
Signed-off-by: Riley Baird <orthogonal@librewrt.org>
[florian: unmangle patch, fix subject]
Signed-off-by: Florian Fainelli <florian@openwrt.org>
SVN-Revision: 40718
... or else "option htmode" is added multiple times to
the second and following device sections.
Signed-off-by: Reiner Herrmann <reiner@reiner-h.de>
SVN-Revision: 40711
This patch adds a config option to enable DFS in ath9k and ath10k
drivers (with ath10k you need the AP-branch firmware). I'm not entirely
sure about the regulatory compliance issues, though. As far as I
understand, enabling the DFS_CERTIFIED config options implies that the
device is certified for DFS. No doubt the original firmware has obtained
such a certification, but not with the open source drivers. I suppose
that as long as this is disabled in default builds (like ATH_USER_REGD)
everything should be fine, but it would be nice to have out-of-the-box
OpenWrt support for DFS. I'm also not sure whether the description of
the configuration option should say something about regulatory compliance.
Signed-off-by: Matti Laakso <malaakso@elisanet.fi>
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
SVN-Revision: 40692
Felix Fietkau
Hauke Mehrtens
Steven Barth
John Crispin
Zoltan Herpai
Jo-Philipp Wich
Luka Perkov
Florian Fainelli