2.8 KiB
SPI
Serial Peripheral Interface (SPI), is a type of communication protocol used primarily in microcontroller-based systems The controller selects a chip it send and receive information to and from. NOR flash chips with an SPI interface are commonly used as firmware boot chip. SPI has one read and one write line. In QSPI mode, 4 lines are used in parallel.
SPI mainly involves four lines or wires:
- MOSI (Master Out Slave In): This is the line through which the master sends data to the slave.
- MISO (Master In Slave Out): Through this line, the slave sends data back to the master.
- SCLK (Serial Clock): This line is like a clock ticking, controlled by the master. It helps in timing the data transfer, ensuring both master and slave are synchronized.
- SS (Slave Select)/CS (Chip Select): When the master wants to talk to a particular slave, it uses this line to select the slave.
Interact via SPI
- Connect to HydraBus and communicate via the SPI protocol
screen /dev/ttyACM0 115200 spi # RDID Read Identification Sequence example [ 0x9f hd:3 ] # Read data from the beginning of the chip [ 0x03 0x00 0x00 0x00 hd:1024 ]
Dump Firmware via SPI
sudo raspi-confi > Interface > SPI(P4)
NOTE: might need a press/hold the reset button
# check
sudo flashrom -p linux spi:dev=/dev/spidev0.0,spispeed=1000
# dump
sudo flashrom -p linux spi:dev=/dev/spidev0.0,spispeed=1000 -r dump.bin
An ESP8266 and ESP32 have several SPI busses available in hardware, SPI0 is hooked up to it's own internal flash and is not intended for use, but the HSPI and VSPI busses can be used in combination with a SOIC-8 clamp to read from SPI NOR chips. cheap clips have a tendency to jump off the chips, pomona 5250 has a better grip.
$ python ./esptool.py read_flash --spi-connection HSPI 0 0x400000 flash_dump.bin
SPIFFS
$ cd ~/.arduino15/packages/esp32/tools/esptool/2.3.1
$ python ./esptool.py -p /dev/ttyUSB0 -b 460800 read_flash 0x300000 0x0fb000 /tmp/spiffs.bin
$ cd ~/.arduino15/packages/esp32/tools/mkspiffs/0.2.3
$ ./mkspiffs -u /tmp/data -p 256 -b 8192 -s 1028096 /tmp/spiffs/bin
ESP32 Diagrams
Color coded which pins can be connected from the ESP HSPI pins to an SPI flash. The pink interfaces (DQ1 and DQ2) are optional, they are only used in QSPI mode.
