So in the previous refactor, we made the dedicated method to parse
usernames and passwords from the split up config values. However, that
didn't work, because on a single iteration of the loop, you only have
access to a possible username OR password. The other matching key will
be another iteration of the loop. Because of this, no credential pairs
were being reported.
The only way I can see around this (maybe because I'm a ruby newb) would
be to iterate over configs, and if the user or password regex matches,
add the matching value to a hash, which is identified by a key for both
user & pass. Then upon completion of the loop, it'd iterate over the
hash, finding keys that had both user & pass values.
Added targets for 8 specific targets that I've tested: Cisco WAP4410N,
Honeywell WAP-PL2 IP Camera, Netgear DG834, Netgear DG834G, Netgear
DG834PN, Netgear DGN1000, Netgear DSG835, Netgear WPNT834
Added functionality to the CmdStagerEcho mix-in to support encoding via
octal instead of hex based on the :enc_type option. This is because many
devices would not output hex encoded values properly.
Added options on a per-target basis for the PackFormat (endian pack()
values for communication), UploadPath (because /tmp wasn't always
writable), and PayloadEncode (previously mentioned octal encoding
option)
Note for some reason, some devices communicate over one endianness, but
then require a payload for the other endianess. I'm not sure what's
causing this, but if those specific combinations are not used, the
exploit fails. More research may be required for this.
sinn3r
jvazquez-r7
William Vu
joev
sgabe
Matt Andreko
Tod Beardsley