Hauke Mehrtens 7c4a6af247 broadcom-diag: support for the WNDR3700v3 ... I recently picked up a WNDR3700 to put OpenWRT on, and only after tearing into the box did I find it was one of the v3 boards, with poor OpenWRT support. This patch should add the board detection and LED/button control to the broadcom-diag module, and should generate a netgear .chk image that the bootloader and stock firmware will accept. The changes to the broadcom-diag module are more than a few lines because the WNDR3700v3 is driving its LEDs through an HC164 8-bit shift register. Signed-off-by: Owen Kirby <osk@exegin.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36482 3c298f89-4303-0410-b956-a3cf2f4a3e73		2013-04-28 21:11:17 +00:00
..
base-files	brcm47xx: use old partition names again for kernel 3.8	2013-04-06 22:22:26 +00:00
image	broadcom-diag: support for the WNDR3700v3	2013-04-28 21:11:17 +00:00
patches-3.6	brcm47xx: add board detection for NETGEAR WNDR4500 V2	2013-04-28 18:19:31 +00:00
patches-3.8	brcm47xx: add board detection for NETGEAR WNDR4500 V2	2013-04-28 18:19:31 +00:00
profiles	brcm47xx: fix name of kmod-ocf-ubsec-ssb	2013-02-06 22:51:25 +00:00
Makefile	brcm47xx: use kernel 3.8.10 as default kernel	2013-04-28 18:25:16 +00:00
base-files.mk	add back the base-files/image code from brcm-2.4 to brcm47xx	2010-06-26 20:41:49 +00:00
config-3.6	brcm47xx: refresh config	2013-03-10 20:42:26 +00:00
config-3.8	brcm47xx: refresh config	2013-03-10 20:42:26 +00:00
modules.mk	brcm47xx: BGMAC - Adjust AutoLoad number to be prior to switch modules	2013-02-16 16:27:33 +00:00