Hauke Mehrtens 55fc9a401d [brcm47xx]: activate failsafe on all ports of the switch and not just port 0. ... Sometimes the port 0 was the WAN port or there could be some device where the port 0 is not wired to an actual Ethernet port. Now telnet in failsafe will listen on all ports of the switch so user do not have to search for the correct port any more. This change will make the switch leak traffic between the WAN and the LAN port, but you should not use failsafe while connected to a untrusted network. git-svn-id: svn://svn.openwrt.org/openwrt/trunk@33544 3c298f89-4303-0410-b956-a3cf2f4a3e73		2012-09-25 14:04:59 +00:00
..
03_init_hotplug_failsafe_brcm	add back the base-files/image code from brcm-2.4 to brcm47xx	2010-06-26 20:41:49 +00:00
05_init_interfaces_brcm	add back the base-files/image code from brcm-2.4 to brcm47xx	2010-06-26 20:41:49 +00:00
05_reset_button_brcm	[brcm47xx]: target (base-files): Fixed failsafe mode by adding back insmod diag	2010-07-15 02:46:03 +00:00
05_set_failsafe_switch_brcm	add back the base-files/image code from brcm-2.4 to brcm47xx	2010-06-26 20:41:49 +00:00
15_mount_proc_brcm	add back the base-files/image code from brcm-2.4 to brcm47xx	2010-06-26 20:41:49 +00:00
15_set_preinit_interface_brcm	[brcm47xx]: activate failsafe on all ports of the switch and not just port 0.	2012-09-25 14:04:59 +00:00
20_failsafe_net_echo_brcm	add back the base-files/image code from brcm-2.4 to brcm47xx	2010-06-26 20:41:49 +00:00
20_failsafe_set_boot_wait_brcm	add back the base-files/image code from brcm-2.4 to brcm47xx	2010-06-26 20:41:49 +00:00