Since svn rev [38557] we support power buttons, for example
the ACPI power button on x86 machines.
Add a simple shutdown script to /etc/rc.button, to gracefully shutdown
the machine after the power button is pressed.
Tested on x86 and x86_64 in a kvm virtual machine.
Signed-off-by: Stefan Hellermann <stefan@the2masters.de>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@40909 3c298f89-4303-0410-b956-a3cf2f4a3e73
It is base on rt3662 soc with dual band 802.11n
wireless router. Use rtl8367R switch chip.
This patch adds a profile for this board.
It use seama image header. so i also enable it
on kernel config.
Signed-off-by: michael lee <igvtee@gmail.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@40908 3c298f89-4303-0410-b956-a3cf2f4a3e73
Hi Hartmut,
Thanks for your feedback, I have reformated the patch accordingly.
Added support for Teltonika RUT5XX hardware.
Signed-off-by: Steffen Weinreich <steve@weinreich.org>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@40907 3c298f89-4303-0410-b956-a3cf2f4a3e73
Before this patch, doing `/e/c/network restart' will emit the folloing
error by `ubus network.wireless down "{}"' because netifd already quit
by that time.
Command failed: not found
Signed-off-by: Yousong Zhou <yszhou4tech@gmail.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@40906 3c298f89-4303-0410-b956-a3cf2f4a3e73
The chipidea USB OTG controller is dual-role and supports both host and device
modes. Enable device mode.
Tested on Gateworks Ventana imx6 board with g_ether.
Are there any other targets out there that use the CHIPIDEA controller? If so
testing is needed for those.
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@40905 3c298f89-4303-0410-b956-a3cf2f4a3e73
Since logd haven't started at this point, logging does not work.
Signed-off-by: Nuno Goncalves <nunojpg@gmail.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@40904 3c298f89-4303-0410-b956-a3cf2f4a3e73
This patch adds "Asus RT-N10+" as a target option in menuconfig. The device has been supported for a while but is currently missing a profile (.mk).
Signed-off-by: Randolph Kuntz <8D961920@galaxymail.org>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@40903 3c298f89-4303-0410-b956-a3cf2f4a3e73
This patch adds support for the PCIe controller
In addition to the PCIe controller a sprom is now provided by a device
tree driver to bcma from some nvram.
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@40880 3c298f89-4303-0410-b956-a3cf2f4a3e73
Patch sets the source IP address of DHCP request messages during rebind to the IP address
assigned to the udhcpc client. Source address 0.0.0.0 can only be used by a client prior
to obtaining its IP address (see RFC2131 § 4.1). Source IP address behavior lines up now with
the ISC dhcp client implementation for DHCP request messages during rebind and DHCP release
messages.
Signed-off-by: Hans Dedecker <dedeckeh@gmail.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@40878 3c298f89-4303-0410-b956-a3cf2f4a3e73
Support is added only for kernel 3.14 - do not show it until
the switch is made.
Following uboot env changes are needed to make it work on stock uboot:
---
setenv owrt_bootargs_root ubi.mtd=3 root=ubi0:rootfs rootfstype=ubifs rw
setenv owrt_mtdparts mtdparts=orion_nand:0x80000@0x0(uboot),0x20000@0x80000(uboot_env),0x200000@0x200000(kernel),-@0x400000(root)
setenv owrt_boot nand read.e \${loadaddr} 0x200000 0x200000 \; setenv bootargs \$(console) \$(owrt_mtdparts) \${owrt_bootargs_root} \; bootm \${loadaddr}
setenv bootcmd run owrt_boot
saveenv
---
Signed-off-by: Luka Perkov <luka@openwrt.org>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@40871 3c298f89-4303-0410-b956-a3cf2f4a3e73
Many of the 4G/LTE and 3G modems utilize the QMI-protocol to control the
modem. At the moment there is no support for them in OpenWrt. This
patch adds support for them in the form of a netifd script and a
control utility. Tested with Huawei E398 and ZTE MF820D (which requires
a delay of ~30 s before responding to QMI commands). I put myself up as
the maintainer, feel free to change this if you desire.
Signed-off-by: Matti Laakso <malaakso@elisanet.fi>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@40868 3c298f89-4303-0410-b956-a3cf2f4a3e73
550-ubifs-symlink-xattr-support.patch contains a reference to the
by now obsolete config symbol CONFIG_UBIFS_FS_XATTR which leads to
the functionality originally added by the patch in r30794 being
left-out during compile since commit 1bdcc63112a0
("UBIFS: remove xattr Kconnfig option") in v3.5.
Fix this by removing the #ifdef from all affected kernels as XATTR
support is now always enabled for UBIFS as well.
Signed-off-by: Daniel Golle <daniel@makrotopia.org>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@40864 3c298f89-4303-0410-b956-a3cf2f4a3e73
John Crispin
Felix Fietkau
Luka Perkov
Steven Barth
Zoltan HERPAI
Hauke Mehrtens
Jo-Philipp Wich