Replaced non-working (on NAS100d) redboot byteswap partition truncate patch with the one that has been tested on NSLU2, NAS100d, Loft, etc., accepted by linux-mtd, and should be in 2.6.20
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@5813 3c298f89-4303-0410-b956-a3cf2f4a3e73master
parent
3cecb2e91d
commit
a549eaf6e1
|
@ -0,0 +1,61 @@
|
|||
Redboot supports storing the FIS directory and the RedBoot
|
||||
configuration information in the same block of flash memory. This is
|
||||
not the most common RedBoot configuration, but it is used on
|
||||
commercially available boards supported by the kernel.
|
||||
|
||||
A recent patch to mtd/redboot.c (http://lkml.org/lkml/2006/3/20/410)
|
||||
which corrected the skipping of deleted table entries has exposed the
|
||||
latent problem of the kernel redboot parser running off the end of the
|
||||
FIS directory and interpreting the RedBoot configuration information
|
||||
as table entries.
|
||||
|
||||
This patch terminates the table parsing when the first truly empty
|
||||
entry is found (table entry deletion only clears the first byte of the
|
||||
name, so two cleared bytes in a row indicates the end of the table),
|
||||
thereby supporting the combined redboot FIS directory and RedBoot
|
||||
configuration information flash layout scenario.
|
||||
|
||||
Signed-off-by: Rod Whitby <rod@whitby.id.au>
|
||||
--
|
||||
|
||||
Index: linux-2.6.19/drivers/mtd/redboot.c
|
||||
===================================================================
|
||||
--- linux-2.6.19.orig/drivers/mtd/redboot.c
|
||||
+++ linux-2.6.19/drivers/mtd/redboot.c
|
||||
@@ -96,7 +96,19 @@ static int parse_redboot_partitions(stru
|
||||
*/
|
||||
if (swab32(buf[i].size) == master->erasesize) {
|
||||
int j;
|
||||
- for (j = 0; j < numslots && buf[j].name[0] != 0xff; ++j) {
|
||||
+ for (j = 0; j < numslots; ++j) {
|
||||
+
|
||||
+ /* A single 0xff denotes a deleted entry.
|
||||
+ * Two of them in a row is the end of the table.
|
||||
+ */
|
||||
+ if (buf[j].name[0] == 0xff) {
|
||||
+ if (buf[j].name[1] == 0xff) {
|
||||
+ break;
|
||||
+ } else {
|
||||
+ continue;
|
||||
+ }
|
||||
+ }
|
||||
+
|
||||
/* The unsigned long fields were written with the
|
||||
* wrong byte sex, name and pad have no byte sex.
|
||||
*/
|
||||
@@ -123,8 +135,13 @@ static int parse_redboot_partitions(stru
|
||||
for (i = 0; i < numslots; i++) {
|
||||
struct fis_list *new_fl, **prev;
|
||||
|
||||
- if (buf[i].name[0] == 0xff)
|
||||
- continue;
|
||||
+ if (buf[i].name[0] == 0xff) {
|
||||
+ if (buf[i].name[1] == 0xff) {
|
||||
+ break;
|
||||
+ } else {
|
||||
+ continue;
|
||||
+ }
|
||||
+ }
|
||||
if (!redboot_checksum(&buf[i]))
|
||||
break;
|
||||
|
|
@ -1,61 +0,0 @@
|
|||
diff -urN linux-2.6.19.old/drivers/mtd/redboot.c linux-2.6.19.dev/drivers/mtd/redboot.c
|
||||
--- linux-2.6.19.old/drivers/mtd/redboot.c 2006-11-29 22:57:37.000000000 +0100
|
||||
+++ linux-2.6.19.dev/drivers/mtd/redboot.c 2006-12-14 03:13:35.000000000 +0100
|
||||
@@ -92,22 +92,47 @@
|
||||
* swab32(erasesize) then we know we are looking at
|
||||
* a byte swapped FIS directory - swap all the entries!
|
||||
* (NOTE: this is 'size' not 'data_length'; size is
|
||||
- * the full size of the entry.)
|
||||
+ * the full size of the entry.)
|
||||
+ *
|
||||
+ * Handle cases where the FIS directory is less than
|
||||
+ * a full erase block (like combine FIS directory
|
||||
+ * and RedBoot config).
|
||||
+ *
|
||||
+ * IMHO the best solution would be to compute the
|
||||
+ * flash address of the RedBoot FIS directory and
|
||||
+ * compare that with the entry in the FIS directory
|
||||
+ * entry swabbed. However, I haven't yet figured out
|
||||
+ * how to compute that.
|
||||
*/
|
||||
- if (swab32(buf[i].size) == master->erasesize) {
|
||||
+
|
||||
+ unsigned long erasesize_mask = master->erasesize -1;
|
||||
+ unsigned long eraseaddr_mask = 0xFFFFFFFF ^ erasesize_mask;
|
||||
+
|
||||
+ if (((swab32(buf[i].size)+erasesize_mask)
|
||||
+ & eraseaddr_mask) == master->erasesize) {
|
||||
int j;
|
||||
- for (j = 0; j < numslots && buf[j].name[0] != 0xff; ++j) {
|
||||
+
|
||||
+ /* N.B. The full table being processed so adjust size now */
|
||||
+ numslots = swab32(buf[i].size) / sizeof (struct fis_image_desc);
|
||||
+ for (j = 0; j < numslots; ++j) {
|
||||
/* The unsigned long fields were written with the
|
||||
* wrong byte sex, name and pad have no byte sex.
|
||||
+ *
|
||||
+ * Only process non-deleted entries. Don't exit early.
|
||||
*/
|
||||
- swab32s(&buf[j].flash_base);
|
||||
- swab32s(&buf[j].mem_base);
|
||||
- swab32s(&buf[j].size);
|
||||
- swab32s(&buf[j].entry_point);
|
||||
- swab32s(&buf[j].data_length);
|
||||
- swab32s(&buf[j].desc_cksum);
|
||||
- swab32s(&buf[j].file_cksum);
|
||||
+ if (buf[j].name[0] != 0xff) {
|
||||
+ swab32s(&buf[j].flash_base);
|
||||
+ swab32s(&buf[j].mem_base);
|
||||
+ swab32s(&buf[j].size);
|
||||
+ swab32s(&buf[j].entry_point);
|
||||
+ swab32s(&buf[j].data_length);
|
||||
+ swab32s(&buf[j].desc_cksum);
|
||||
+ swab32s(&buf[j].file_cksum);
|
||||
+ }
|
||||
}
|
||||
+ } else {
|
||||
+ /* Update numslots based on actual FIS directory size */
|
||||
+ numslots = buf[i].size / sizeof (struct fis_image_desc);
|
||||
}
|
||||
break;
|
||||
}
|
Loading…
Reference in New Issue