ar71xx: Remove TX/RX delay from pll_1000 for OM5P-AN
The tx/rx delay bits in the ETH_XMII_CONTROL register have to be unset when the enable_rgmii_rx_delay/enable_rgmii_tx_delay will be set in the AT803x PHY. Othwise the throughput in gigabit mode is heavily reduced. Signed-off-by: Sven Eckelmann <sven@open-mesh.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@45521 3c298f89-4303-0410-b956-a3cf2f4a3e73master
parent
1b96b5271c
commit
6bc40a3f04
|
@ -202,7 +202,7 @@ static void __init om5p_an_setup(void)
|
|||
ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII;
|
||||
ath79_eth0_data.mii_bus_dev = &ath79_mdio0_device.dev;
|
||||
ath79_eth0_data.phy_mask = BIT(7);
|
||||
ath79_eth0_pll_data.pll_1000 = 0x1a000000;
|
||||
ath79_eth0_pll_data.pll_1000 = 0x02000000;
|
||||
ath79_eth0_pll_data.pll_100 = 0x00000101;
|
||||
ath79_eth0_pll_data.pll_10 = 0x00001313;
|
||||
ath79_register_eth(0);
|
||||
|
|
Loading…
Reference in New Issue