openwrt/target/linux/lantiq/files-4.14/arch/mips/boot/dts/FRITZ7412.dts

232 lines
3.9 KiB
Plaintext

// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
#include "vr9.dtsi"
#include <dt-bindings/input/input.h>
#include <dt-bindings/mips/lantiq_rcu_gphy.h>
/ {
compatible = "avm,fritz7412", "lantiq,xway", "lantiq,vr9";
model = "AVM FRITZ!Box 7412";
chosen {
bootargs = "console=ttyLTQ0,115200";
};
aliases {
led-boot = &power_green;
led-failsafe = &power_red;
led-running = &power_green;
led-upgrade = &power_red;
led-dsl = &info;
led-wifi = &wifi;
};
memory@0 {
reg = <0x0 0x8000000>;
};
keys {
compatible = "gpio-keys-polled";
poll-interval = <100>;
wps {
label = "wps";
gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
linux,code = <KEY_WPS_BUTTON>;
};
dect {
label = "dect";
gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
linux,code = <KEY_PHONE>;
};
};
leds {
compatible = "gpio-leds";
power_green: power_green {
label = "fritz7412:green:power";
gpios = <&gpio 6 GPIO_ACTIVE_LOW>;
default-state = "keep";
};
power_red: power_red {
label = "fritz7412:red:power";
gpios = <&gpio 5 GPIO_ACTIVE_LOW>;
};
fon {
label = "fritz7412:green:fon";
gpios = <&gpio 34 GPIO_ACTIVE_LOW>;
};
dect {
label = "fritz7412:green:dect";
gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
};
wifi: wifi {
label = "fritz7412:green:wifi";
gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
};
info: info {
label = "fritz7412:green:info";
gpios = <&gpio 35 GPIO_ACTIVE_LOW>;
};
};
};
&localbus {
nand@0 {
compatible = "lantiq,nand-xway";
bank-width = <2>;
reg = <0 0x0 0x2000000>;
#address-cells = <1>;
#size-cells = <1>;
lantiq,cs = <1>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "urlader";
reg = <0x0 0x40000>;
read-only;
};
partition@40000 {
label = "nand-tffs";
reg = <0x40000 0x400000>;
read-only;
};
partition@440000 {
label = "kernel";
reg = <0x440000 0x400000>;
};
partition@840000 {
label = "ubi";
reg = <0x840000 0x3000000>;
};
partition@3840000 {
label = "reserved-kernel";
reg = <0x3840000 0x400000>;
read-only;
};
partition@3c40000 {
label = "reserved-filesystem";
reg = <0x3c40000 0x3000000>;
read-only;
};
partition@6c40000 {
label = "config";
reg = <0x6c40000 0x400000>;
read-only;
};
partition@6e40000 {
label = "nand-filesystem";
reg = <0x6e40000 0x400000>;
read-only;
};
};
};
};
&pcie0 {
status = "okay";
gpio-reset = <&gpio 11 GPIO_ACTIVE_HIGH>;
pcie@0 {
reg = <0 0 0 0 0>;
#interrupt-cells = <1>;
#size-cells = <2>;
#address-cells = <3>;
device_type = "pci";
wifi@168c,002e {
compatible = "pci168c,002e";
reg = <0 0 0 0 0>;
qca,no-eeprom; /* load from ath9k-eeprom-pci-0000:01:00.0.bin */
};
};
};
&gpio {
pinctrl-names = "default";
pinctrl-0 = <&state_default>;
state_default: pinmux {
mdio {
lantiq,groups = "mdio";
lantiq,function = "mdio";
};
pcie-rst {
lantiq,pins = "io11";
lantiq,open-drain = <1>;
lantiq,output = <1>;
};
nand-mux {
lantiq,groups = "nand cle", "nand ale",
"nand rd", "nand cs1",
"nand rdy";
lantiq,function = "ebu";
};
nand-pins {
lantiq,pins = "io13", "io24", "io49";
lantiq,pull = <1>;
};
};
};
&gphy0 {
lantiq,gphy-mode = <GPHY_MODE_FE>;
};
&eth0 {
lantiq,phys = <&gphy0>;
interface@0 {
compatible = "lantiq,xrx200-pdi";
#address-cells = <1>;
#size-cells = <0>;
reg = <0>;
mac-address = [ 00 11 22 33 44 55 ];
lantiq,switch;
ethernet@2 {
compatible = "lantiq,xrx200-pdi-port";
reg = <2>;
phy-mode = "gmii";
phy-handle = <&phy11>;
};
};
mdio@0 {
#address-cells = <1>;
#size-cells = <0>;
reg = <0>;
compatible = "lantiq,xrx200-mdio";
phy11: ethernet-phy@11 {
reg = <0x11>;
compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
};
};
};
&vmmc {
status = "okay";
};