openwrt/target/linux/brcm47xx
Hauke Mehrtens ca7f9638d5 broadcom-diag: support for the WNDR3700v3
I recently picked up a WNDR3700 to put OpenWRT on, and only after tearing into the box did I find it
was one of the v3 boards, with poor OpenWRT support. This patch should add the board detection and
LED/button control to the broadcom-diag module, and should generate a netgear .chk image that the
bootloader and stock firmware will accept.

The changes to the broadcom-diag module are more than a few lines because the WNDR3700v3 is driving
its LEDs through an HC164 8-bit shift register.

Signed-off-by: Owen Kirby <osk@exegin.com>

SVN-Revision: 36482
2013-04-28 21:11:17 +00:00
..
base-files brcm47xx: use old partition names again for kernel 3.8 2013-04-06 22:22:26 +00:00
image broadcom-diag: support for the WNDR3700v3 2013-04-28 21:11:17 +00:00
patches-3.6 brcm47xx: add board detection for NETGEAR WNDR4500 V2 2013-04-28 18:19:31 +00:00
patches-3.8 brcm47xx: add board detection for NETGEAR WNDR4500 V2 2013-04-28 18:19:31 +00:00
profiles brcm47xx: fix name of kmod-ocf-ubsec-ssb 2013-02-06 22:51:25 +00:00
Makefile brcm47xx: use kernel 3.8.10 as default kernel 2013-04-28 18:25:16 +00:00
base-files.mk
config-3.6 brcm47xx: refresh config 2013-03-10 20:42:26 +00:00
config-3.8 brcm47xx: refresh config 2013-03-10 20:42:26 +00:00
modules.mk brcm47xx: BGMAC - Adjust AutoLoad number to be prior to switch modules 2013-02-16 16:27:33 +00:00