openwrt/target/linux/ath79/dts/ar9330_pqi_air-pen.dts

145 lines
2.1 KiB
Plaintext

// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "ar9330.dtsi"
/ {
model = "PQI Air-Pen";
compatible = "pqi,air-pen", "qca,ar9330";
aliases {
serial0 = &uart;
led-boot = &led_wlan;
led-failsafe = &led_wlan;
led-upgrade = &led_wlan;
};
leds {
compatible = "gpio-leds";
led_wlan: wlan {
label = "air-pen:blue:wlan";
gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
linux,default-trigger = "phy0tpt";
};
wps {
label = "air-pen:blue:wps";
gpios = <&gpio 23 GPIO_ACTIVE_HIGH>;
};
};
keys {
compatible = "gpio-keys";
wps {
label = "wps";
linux,code = <KEY_WPS_BUTTON>;
gpios = <&gpio 22 GPIO_ACTIVE_HIGH>;
debounce-interval = <60>;
};
reset {
label = "reset";
linux,code = <KEY_RESTART>;
gpios = <&gpio 12 GPIO_ACTIVE_HIGH>;
debounce-interval = <60>;
};
};
};
&uart {
status = "okay";
};
&usb {
dr_mode = "host";
status = "okay";
};
&usb_phy {
status = "okay";
};
&spi {
status = "okay";
num-cs = <1>;
flash@0 {
compatible = "jedec,spi-nor";
spi-max-frequency = <50000000>;
reg = <0>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "u-boot";
reg = <0x000000 0x040000>;
read-only;
};
partition@40000 {
label = "u-boot-env";
reg = <0x040000 0x010000>;
};
art: partition@50000 {
label = "art";
reg = <0x050000 0x010000>;
read-only;
};
partition@60000 {
label = "NVRAM";
reg = <0x060000 0x010000>;
read-only;
};
partition@70000 {
compatible = "denx,uimage";
label = "firmware";
reg = <0x070000 0x780000>;
};
partition@7f0000 {
label = "CONF";
reg = <0x7f0000 0x010000>;
read-only;
};
};
};
};
&eth0 {
status = "okay";
mtd-mac-address = <&art 0x1002>;
gmac-config {
device = <&gmac>;
switch-phy-addr-swap = <0>;
switch-phy-swap = <0>;
};
};
&eth1 {
status = "okay";
compatible = "syscon", "simple-mfd";
};
&wmac {
status = "okay";
mtd-cal-data = <&art 0x1000>;
mtd-mac-address = <&art 0x2>;
};