openwrt/target/linux/ath79/dts/qca9531_engenius_ews511ap.dts

148 lines
2.3 KiB
Plaintext

// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "qca953x.dtsi"
/ {
compatible = "engenius,ews511ap", "qca,qca9531";
model = "EnGenius EWS511AP";
aliases {
led-boot = &led_power;
led-failsafe = &led_power;
led-running = &led_power;
led-upgrade = &led_power;
};
keys {
compatible = "gpio-keys";
pinctrl-names = "default";
pinctrl-0 = <&jtag_disable_pins>;
reset {
label = "reset";
linux,code = <KEY_RESTART>;
gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
};
};
leds {
compatible = "gpio-leds";
led_power: power {
label = "ews511ap:amber:power";
gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
default-state = "on";
};
lan1 {
label = "ews511ap:blue:lan1";
gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
};
lan2 {
label = "ews511ap:blue:lan2";
gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
};
wlan2g {
label = "ews511ap:green:wlan2g";
gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
linux,default-trigger = "phy0tpt";
};
wlan5g {
label = "ews511ap:green:wlan5g";
gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
linux,default-trigger = "phy1tpt";
};
};
watchdog {
compatible = "linux,wdt-gpio";
gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
hw_algo = "toggle";
/* hw_margin_ms is actually 300s but driver limits it to 60s */
hw_margin_ms = <60000>;
always-running;
};
};
&wdt {
status = "okay";
};
&rst {
status = "okay";
};
&pcie0 {
status = "okay";
};
&uart {
status = "okay";
};
&spi {
status = "okay";
num-cs = <0>;
flash@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <25000000>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "u-boot";
reg = <0x000000 0x040000>;
read-only;
};
ubootenv: partition@40000 {
label = "u-boot-env";
reg = <0x040000 0x010000>;
};
art: partition@50000 {
label = "art";
reg = <0x050000 0x010000>;
read-only;
};
partition@60000 {
compatible = "denx,uimage";
label = "firmware";
reg = <0x060000 0xfa0000>;
};
};
};
};
&eth0 {
status = "okay";
phy-handle = <&swphy4>;
};
&eth1 {
status = "okay";
};
&wmac {
status = "okay";
mtd-cal-data = <&art 0x1000>;
};