openwrt/target/linux/ath79/dts/ar9331_pisen_wmm003n.dts

127 lines
2.0 KiB
Plaintext

// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "ar9331.dtsi"
/ {
model = "Pisen WMM003N";
compatible = "pisen,wmm003n", "qca,ar9331";
aliases {
serial0 = &uart;
led-boot = &led_system;
led-failsafe = &led_system;
led-running = &led_system;
led-upgrade = &led_system;
};
keys {
compatible = "gpio-keys";
reset {
label = "reset";
linux,code = <KEY_RESTART>;
gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
debounce-interval = <60>;
};
};
leds {
compatible = "gpio-leds";
led_system: system {
label = "pisen:blue:system";
gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
};
};
reg_usb_vbus: reg_usb_vbus {
compatible = "regulator-fixed";
regulator-name = "usb_vbus";
regulator-min-microvolt = <5000000>;
regulator-max-microvolt = <5000000>;
gpio = <&gpio 8 GPIO_ACTIVE_HIGH>;
enable-active-high;
};
};
&spi {
status = "okay";
num-cs = <1>;
flash@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <25000000>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
uboot: partition@0 {
reg = <0x0 0x20000>;
label = "u-boot";
read-only;
};
firmware: partition@20000 {
compatible = "tplink,firmware";
reg = <0x20000 0x7d0000>;
label = "firmware";
};
art: partition@7f0000 {
reg = <0x7f0000 0x10000>;
label = "art";
read-only;
};
};
};
};
&eth0 {
status = "okay";
mtd-mac-address = <&uboot 0x1fc00>;
gmac-config {
device = <&gmac>;
switch-phy-addr-swap = <0>;
switch-phy-swap = <0>;
};
};
&eth1 {
status = "okay";
compatible = "syscon", "simple-mfd";
};
&gpio {
status = "okay";
};
&uart {
status = "okay";
};
&usb {
dr_mode = "host";
vbus-supply = <&reg_usb_vbus>;
status = "okay";
};
&usb_phy {
status = "okay";
};
&wmac {
status = "okay";
mtd-cal-data = <&art 0x1000>;
mtd-mac-address = <&uboot 0x1fc00>;
};