openwrt/target/linux/ath79/dts/qca9561_avm_fritz4020.dts

175 lines
2.8 KiB
Plaintext

// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "qca956x.dtsi"
/ {
compatible = "avm,fritz4020", "qca,qca9560";
model = "AVM FRITZ!Box 4020";
aliases {
led-boot = &led_power;
led-failsafe = &led_info_red;
led-running = &led_power;
led-upgrade = &led_info_red;
};
chosen {
bootargs = "console=ttyS0,115200n8";
};
led_spi {
compatible = "spi-gpio";
#address-cells = <1>;
#size-cells = <0>;
sck-gpios = <&gpio 20 GPIO_ACTIVE_HIGH>;
mosi-gpios = <&gpio 19 GPIO_ACTIVE_HIGH>;
num-chipselects = <0>;
led_gpio: led_gpio@0 {
compatible = "fairchild,74hc595";
reg = <0>;
gpio-controller;
#gpio-cells = <2>;
registers-number = <1>;
spi-max-frequency = <10000000>;
gpio_latch_bit {
gpio-hog;
gpios = <7 GPIO_ACTIVE_HIGH>;
output-high;
line-name = "gpio-latch-bit";
};
};
};
leds {
compatible = "gpio-leds";
led_power: power {
label = "fritz4020:green:power";
gpios = <&led_gpio 2 GPIO_ACTIVE_LOW>;
default-state = "on";
};
wlan {
label = "fritz4020:green:wlan";
gpios = <&led_gpio 3 GPIO_ACTIVE_LOW>;
linux,default-trigger = "phy0tpt";
};
lan {
label = "fritz4020:green:lan";
gpios = <&led_gpio 0 GPIO_ACTIVE_LOW>;
};
wan {
label = "fritz4020:green:wan";
gpios = <&led_gpio 4 GPIO_ACTIVE_LOW>;
};
info {
label = "fritz4020:green:info";
gpios = <&led_gpio 6 GPIO_ACTIVE_LOW>;
};
led_info_red: info_red {
label = "fritz4020:red:info";
gpios = <&led_gpio 1 GPIO_ACTIVE_LOW>;
};
};
keys {
compatible = "gpio-keys";
wps {
label = "WPS button";
linux,code = <KEY_WPS_BUTTON>;
gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
};
wlan {
label = "WLAN button";
linux,code = <KEY_RFKILL>;
gpios = <&gpio 21 GPIO_ACTIVE_LOW>;
};
};
};
&uart {
status = "okay";
};
&gpio {
status = "okay";
};
&spi {
status = "okay";
num-cs = <1>;
flash@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <25000000>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "urlader";
reg = <0x000000 0x020000>;
read-only;
};
partition@1 {
compatible = "avm,eva-firmware";
label = "firmware";
reg = <0x020000 0xee0000>;
};
partition@2 {
label = "tffs (1)";
reg = <0xf00000 0x080000>;
read-only;
};
partition@3 {
label = "tffs (2)";
reg = <0xf80000 0x080000>;
read-only;
};
};
};
};
&eth0 {
status = "okay";
phy-handle = <&swphy0>;
gmac-config {
device = <&gmac>;
switch-phy-addr-swap = <1>;
switch-phy-swap = <1>;
};
};
&eth1 {
status = "okay";
};
&wmac {
status = "okay";
qca,no-eeprom;
};