openwrt/target/linux/ath79/dts/qca9558_trendnet_tew-823dru...

216 lines
3.2 KiB
Plaintext

// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "qca9557.dtsi"
/ {
compatible = "trendnet,tew-823dru", "qca,qca9558";
model = "TRENDNET TEW-823DRU";
chosen {
bootargs = "console=ttyS0,115200n8";
};
aliases {
led-boot = &led_power_green;
led-failsafe = &led_power_green;
led-running = &led_power_green;
led-upgrade = &led_power_green;
};
leds {
compatible = "gpio-leds";
power_orange {
label = "trendnet:orange:power";
gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
};
led_power_green: power_green {
label = "trendnet:green:power";
gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
};
planet_green {
label = "trendnet:green:planet";
gpios = <&gpio 22 GPIO_ACTIVE_LOW>;
};
planet_orange {
label = "trendnet:orange:planet";
gpios = <&gpio 23 GPIO_ACTIVE_LOW>;
};
};
keys {
compatible = "gpio-keys";
reset {
label = "Reset button";
linux,code = <KEY_RESTART>;
gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
debounce-interval = <60>;
};
wps {
label = "WPS button";
linux,code = <KEY_WPS_BUTTON>;
gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
debounce-interval = <60>;
};
};
};
&pcie0 {
status = "okay";
};
&pcie1 {
status = "okay";
};
&uart {
status = "okay";
};
&gpio {
status = "okay";
};
&usb_phy0 {
status = "okay";
};
&usb0 {
#address-cells = <1>;
#size-cells = <0>;
status = "okay";
hub_port0: port@1 {
reg = <1>;
#trigger-source-cells = <0>;
};
};
&usb_phy1 {
status = "okay";
};
&usb1 {
#address-cells = <1>;
#size-cells = <0>;
status = "okay";
hub_port1: port@1 {
reg = <1>;
#trigger-source-cells = <0>;
};
};
&spi {
status = "okay";
num-cs = <1>;
flash@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <25000000>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "u-boot";
reg = <0x000000 0x030000>;
read-only;
};
partition@30000 {
label = "nvram";
reg = <0x030000 0x010000>;
read-only;
};
partition@40000 {
compatible = "denx,uimage";
label = "firmware";
reg = <0x040000 0xef0000>;
};
partition@f30000 {
label = "lang";
reg = <0xf30000 0x030000>;
read-only;
};
partition@f60000 {
label = "my-dlink";
reg = <0xf60000 0x080000>;
read-only;
};
partition@fe0000 {
label = "mac";
reg = <0xfe0000 0x010000>;
read-only;
};
art: partition@ff0000 {
label = "art";
reg = <0xff0000 0x010000>;
read-only;
};
};
};
};
&mdio0 {
status = "okay";
phy0: ethernet-phy@0 {
reg = <0>;
qca,ar8327-initvals = <
0x04 0x00080080 /* PORT0 PAD MODE CTRL */
0x0c 0x07600000 /* PORT6 PAD MODE CTRL */
0x10 0x81000080 /* POWER_ON_STRIP */
0x7c 0x0000007e /* PORT0_STATUS */
0x94 0x0000007e /* PORT6 STATUS */
>;
};
};
&eth0 {
status = "okay";
phy-handle = <&phy0>;
pll-data = <0x56000000 0x00000101 0x00001616>;
gmac-config {
device = <&gmac>;
rgmii-enabled = <1>;
};
};
&eth1 {
status = "okay";
pll-data = <0x03000101 0x00000101 0x00001616>;
fixed-link {
speed = <1000>;
full-duplex;
};
};
&wmac {
status = "okay";
mtd-cal-data = <&art 0x1000>;
};