openwrt/target/linux/ath79/dts/ar9331_alfa-network_ap121f.dts

139 lines
2.0 KiB
Plaintext

// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "ar9331.dtsi"
/ {
model = "ALFA Network AP121F";
compatible = "alfa-network,ap121f", "qca,ar9331";
aliases {
label-mac-device = &wmac;
led-boot = &led_vpn;
led-failsafe = &led_vpn;
led-upgrade = &led_vpn;
serial0 = &uart;
};
keys {
compatible = "gpio-keys";
reset {
label = "reset";
linux,code = <KEY_RESTART>;
gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
};
switch {
label = "switch";
linux,code = <BTN_0>;
gpios = <&gpio 21 GPIO_ACTIVE_HIGH>;
};
};
leds {
compatible = "gpio-leds";
lan {
label = "ap121f:green:lan";
gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
};
led_vpn: vpn {
label = "ap121f:green:vpn";
gpios = <&gpio 27 GPIO_ACTIVE_LOW>;
};
wlan {
label = "ap121f:green:wlan";
gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
linux,default-trigger = "phy0tpt";
};
};
};
&eth0 {
status = "okay";
mtd-mac-address = <&art 0x0>;
gmac-config {
device = <&gmac>;
switch-phy-addr-swap = <0>;
switch-phy-swap = <0>;
};
};
&eth1 {
status = "okay";
compatible = "syscon", "simple-mfd";
};
&gpio {
status = "okay";
};
&spi {
status = "okay";
num-cs = <1>;
flash@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <25000000>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "u-boot";
reg = <0x000000 0x030000>;
read-only;
};
partition@30000 {
label = "u-boot-env";
reg = <0x030000 0x010000>;
};
art: partition@40000 {
label = "art";
reg = <0x040000 0x010000>;
read-only;
};
partition@50000 {
compatible = "denx,uimage";
label = "firmware";
reg = <0x050000 0xfb0000>;
};
};
};
};
&uart {
status = "okay";
};
&usb {
status = "okay";
dr_mode = "host";
};
&usb_phy {
status = "okay";
};
&wmac {
status = "okay";
mtd-cal-data = <&art 0x1000>;
};