openwrt/target/linux/ath79/dts/ar7242_ubnt_sw.dtsi

143 lines
2.2 KiB
Plaintext

// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "ar7242.dtsi"
/ {
compatible = "qca,ar7242";
model = "Ubiquiti Networks SW board";
chosen {
bootargs = "console=ttyS0,115200n8";
};
aliases {
led-boot = &led_usr;
led-failsafe = &led_usr;
led-running = &led_usr;
led-upgrade = &led_usr;
};
leds {
compatible = "gpio-leds";
led_usr: usr {
label = "ubnt:yellow:usr";
gpios = <&gpio 13 GPIO_ACTIVE_HIGH>;
};
};
keys {
compatible = "gpio-keys";
reset {
linux,code = <KEY_RESTART>;
gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
debounce-interval = <60>;
};
};
gpio_spi {
compatible = "spi-gpio";
#address-cells = <0x1>;
ranges;
sck-gpios = <&gpio 16 GPIO_ACTIVE_HIGH>;
mosi-gpios = <&gpio 15 GPIO_ACTIVE_HIGH>;
cs-gpios = <&gpio 14 GPIO_ACTIVE_HIGH>;
num-chipselects = <1>;
gpio_hc595: gpio_spi@0 {
compatible = "fairchild,74hc595";
reg = <0>;
registers-number = <2>;
spi-max-frequency = <100000>;
enable-gpios = <&gpio 7 GPIO_ACTIVE_HIGH>;
gpio-controller;
#gpio-cells = <2>;
};
};
};
&spi {
status = "okay";
num-cs = <1>;
flash@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <25000000>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
reg = <0x000000 0x040000>;
label = "u-boot";
read-only;
};
partition@40000 {
reg = <0x040000 0x010000>;
label = "u-boot-env";
read-only;
};
partition@50000 {
compatible = "denx,uimage";
reg = <0x050000 0x760000>;
label = "firmware";
};
partition@7b0000 {
reg = <0x7b0000 0x040000>;
label = "cfg";
read-only;
};
art: partition@7f0000 {
reg = <0x7f0000 0x010000>;
label = "art";
read-only;
};
};
};
};
&usb_phy {
status = "okay";
};
&usb {
#address-cells = <1>;
#size-cells = <0>;
status = "okay";
hub_port: port@1 {
reg = <1>;
#trigger-source-cells = <0>;
};
};
&pcie {
status = "okay";
};
&uart {
status = "okay";
};
&eth1 {
status = "okay";
mtd-mac-address = <&art 0x6>;
};