Tomasz Maciej Nowak 3a3d998c12 layerscape: resurrect support for FRDM-LS1012A ... Re-add support for NXP FRDM-LS1012A, which mimics the flash layout of the rest boards supported by LSDK. 0x000000000000-0x000000100000 : "bl2" 0x000000100000-0x000000500000 : "fip" 0x000000500000-0x000000600000 : "u-boot-env" 0x000000600000-0x000000a00000 : "reserved-1" 0x000000a00000-0x000000d00000 : "pfe" 0x000000d00000-0x000000f00000 : "reserved-2" 0x000000f00000-0x000001000000 : "dtb" 0x000001000000-0x000002000000 : "kernel" 0x000002000000-0x000004000000 : "ubifs" Specification SoC: LS1012A single core 800MHz RAM: 512 MB DDR3 Flash: 64 MB QSPI NOR Ethernet: 2x 10/100/1000 Mbps Connectors: µUSB 3.0 OTG µUSB 2.0 (debugging & power input) 2x 3.5mm jack for microphone & headphone (SGTL5000) Arduino Shield expansion with I2C, SPI, UART, and GPIO JTAG LEDS: 3x (non-configurable) Buttons: 1x (reset, non-configurable) Be advised that erasing or writing 64MB flash takes some time to finish. Do not reset the board until all operations end with success, otherwise You'll need external tools to re-program the flash chip. Installation Follow the QSPI programing procedure for LS1012AFRWY board in target/linux/layerscape/README, point 3.3. Don't forget about updating U-Boot environment with MAC addresses of ethernet interfaces, variable 'ethaddr' for eth0 and 'eth1addr' for eth1. As the LSDK images do not support sysupgrade, nor do changes in this commit, it's planed in upcoming submissions. Signed-off-by: Tomasz Maciej Nowak <tomek_n@o2.pl>		2020-03-12 12:59:44 +01:00
..
patches	tfa-layerscape: fix create_pbl and byte_swap host build	2019-07-26 15:21:58 +02:00
Makefile	layerscape: resurrect support for FRDM-LS1012A	2020-03-12 12:59:44 +01:00