openwrt/target/linux/ath79/dts/ar9132_tplink_tl-wr1043nd-v...

154 lines
2.4 KiB
Plaintext

// SPDX-License-Identifier: GPL-2.0
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "ar9132.dtsi"
/ {
compatible = "tplink,tl-wr1043nd-v1", "qca,ar9132";
model = "TP-Link TL-WR1043ND Version 1";
aliases {
led-status = &system;
};
extosc: ref {
compatible = "fixed-clock";
#clock-cells = <0>;
clock-frequency = <40000000>;
};
keys {
compatible = "gpio-keys";
button0 {
label = "reset";
linux,code = <KEY_RESTART>;
gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
debounce-interval = <60>;
};
button1 {
label = "qss";
linux,code = <KEY_WPS_BUTTON>;
gpios = <&gpio 7 GPIO_ACTIVE_LOW>;
debounce-interval = <60>;
};
};
leds {
compatible = "gpio-leds";
usb {
label = "tp-link:green:usb";
gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
default-state = "off";
trigger-sources = <&hub_port>;
linux,default-trigger = "usbport";
};
system: system {
label = "tp-link:green:system";
gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
linux,default-trigger = "heartbeat";
};
qss {
label = "tp-link:green:qss";
gpios = <&gpio 5 GPIO_ACTIVE_HIGH>;
};
wlan {
label = "tp-link:green:wlan";
gpios = <&gpio 9 GPIO_ACTIVE_LOW>;
default-state = "off";
linux,default-trigger = "phy0tpt";
};
};
rtl8366rb {
compatible = "realtek,rtl8366rb";
gpio-sda = <&gpio 18 GPIO_ACTIVE_HIGH>;
gpio-sck = <&gpio 19 GPIO_ACTIVE_HIGH>;
resets = <&rst 8>;
reset-names = "switch";
};
};
&uart {
status = "okay";
};
&pll {
clocks = <&extosc>;
};
&usb {
#address-cells = <1>;
#size-cells = <0>;
status = "okay";
hub_port: port@1 {
reg = <1>;
#trigger-source-cells = <0>;
};
};
&usb_phy {
status = "okay";
};
&spi {
status = "okay";
num-cs = <1>;
flash@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <25000000>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
uboot: partition@0 {
label = "u-boot";
reg = <0x000000 0x020000>;
read-only;
};
partition@20000 {
label = "firmware";
reg = <0x020000 0x7D0000>;
};
art: partition@7F0000 {
label = "art";
reg = <0x7F0000 0x010000>;
read-only;
};
};
};
};
&eth0 {
status = "okay";
phy-mode = "rgmii";
mtd-mac-address = <&uboot 0x1fc00>;
fixed-link {
speed = <1000>;
full-duplex;
};
};
&wmac {
status = "okay";
mtd-cal-data = <&art 0x1000>;
mtd-mac-address = <&uboot 0x1fc00>;
};