openwrt/target/linux/lantiq/dts/FRITZ3370.dts

287 lines
5.4 KiB
Plaintext

/dts-v1/;
#include "vr9.dtsi"
#include <dt-bindings/input/input.h>
/ {
model = "FRITZ3370 - Fritz!Box WLAN 3370";
chosen {
bootargs = "ubi.mtd=1,512 root=/dev/mtdblock9";
};
aliases {
led-boot = &power_green;
led-failsafe = &power_red;
led-running = &power_green;
led-dsl = &dsl;
led-internet = &info_green;
led-wifi = &wifi;
};
memory@0 {
reg = <0x0 0x8000000>;
};
fpi@10000000 {
localbus@0 {
nand-parts@0 {
compatible = "gen_nand", "lantiq,nand-xway";
bank-width = <2>;
reg = <1 0x0 0x2000000>;
#address-cells = <1>;
#size-cells = <1>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "kernel";
reg = <0x0 0x400000>;
};
partition@400000 {
label = "rootfs_ubi";
reg = <0x400000 0x3000000>;
};
partition@3400000 {
label = "vr9_firmware";
reg = <0x3400000 0x400000>;
};
partition@3800000 {
label = "reserved";
reg = <0x3800000 0x3000000>;
};
partition@6800000 {
label = "config";
reg = <0x6800000 0x200000>;
};
partition@6a00000 {
label = "nand-filesystem";
reg = <0x6a00000 0x1600000>;
};
};
};
};
gpio: pinmux@E100B10 {
pinctrl-names = "default";
pinctrl-0 = <&state_default>;
state_default: pinmux {
mdio {
lantiq,groups = "mdio";
lantiq,function = "mdio";
};
nand {
lantiq,groups = "nand cle", "nand ale",
"nand rd", "nand cs1", "nand rdy";
lantiq,function = "ebu";
lantiq,pull = <1>;
};
phy-rst {
lantiq,pins = "io37", "io44";
lantiq,pull = <0>;
lantiq,open-drain = <0>;
lantiq,output = <1>;
};
pcie-rst {
lantiq,pins = "io38";
lantiq,pull = <0>;
lantiq,output = <1>;
};
};
pins_spi_default: pins_spi_default {
spi_in {
lantiq,groups = "spi_di";
lantiq,function = "spi";
};
spi_out {
lantiq,groups = "spi_do", "spi_clk",
"spi_cs4";
lantiq,function = "spi";
lantiq,output = <1>;
};
};
};
ifxhcd@E101000 {
status = "okay";
gpios = <&gpio 5 GPIO_ACTIVE_HIGH
&gpio 14 GPIO_ACTIVE_HIGH>;
lantiq,portmask = <0x3>;
};
};
gphy-xrx200 {
compatible = "lantiq,phy-xrx200";
firmware = "lantiq/vr9_phy11g_a1x.bin";
phys = [ 00 01 ];
};
gpio-keys-polled {
compatible = "gpio-keys-polled";
#address-cells = <1>;
#size-cells = <0>;
poll-interval = <100>;
power {
label = "power";
gpios = <&gpio 1 GPIO_ACTIVE_HIGH>;
linux,code = <KEY_POWER>;
};
/* wifi {
label = "wifi";
gpios = <&gpio 29 GPIO_ACTIVE_HIGH>;
linux,code = <BTN_1>;
};*/
};
gpio-leds {
compatible = "gpio-leds";
power_green: power {
label = "fritz3370:green:power";
gpios = <&gpio 32 GPIO_ACTIVE_LOW>;
default-state = "keep";
};
power_red: power2 {
label = "fritz3370:red:power";
gpios = <&gpio 33 GPIO_ACTIVE_LOW>;
};
info_red {
label = "fritz3370:red:info";
gpios = <&gpio 34 GPIO_ACTIVE_LOW>;
};
wifi: wifi {
label = "fritz3370:green:wlan";
gpios = <&gpio 35 GPIO_ACTIVE_LOW>;
};
dsl: dsl {
label = "fritz3370:green:dsl";
gpios = <&gpio 36 GPIO_ACTIVE_LOW>;
};
lan {
label = "fritz3370:green:lan";
gpios = <&gpio 38 GPIO_ACTIVE_LOW>;
};
info_green: info_green {
label = "fritz3370:green:info";
gpios = <&gpio 47 GPIO_ACTIVE_LOW>;
};
};
};
&spi {
pinctrl-names = "default";
pinctrl-0 = <&pins_spi_default>;
status = "ok";
m25p80@4 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "jedec,spi-nor";
reg = <4 0>;
spi-max-frequency = <1000000>;
partition@0 {
reg = <0x0 0x20000>;
label = "urlader";
read-only;
};
partition@20000 {
reg = <0x20000 0x10000>;
label = "tffs (1)";
read-only;
};
partition@30000 {
reg = <0x30000 0x10000>;
label = "tffs (2)";
read-only;
};
};
};
&eth0 {
lan: interface@0 {
compatible = "lantiq,xrx200-pdi";
#address-cells = <1>;
#size-cells = <0>;
reg = <0>;
mac-address = [ 00 11 22 33 44 55 ];
lantiq,switch;
ethernet@0 {
compatible = "lantiq,xrx200-pdi-port";
reg = <0>;
phy-mode = "rgmii";
phy-handle = <&phy0>;
gpios = <&gpio 37 GPIO_ACTIVE_HIGH>;
};
ethernet@1 {
compatible = "lantiq,xrx200-pdi-port";
reg = <1>;
phy-mode = "rgmii";
phy-handle = <&phy1>;
gpios = <&gpio 44 GPIO_ACTIVE_HIGH>;
};
ethernet@2 {
compatible = "lantiq,xrx200-pdi-port";
reg = <2>;
phy-mode = "gmii";
phy-handle = <&phy11>;
};
ethernet@3 {
compatible = "lantiq,xrx200-pdi-port";
reg = <4>;
phy-mode = "gmii";
phy-handle = <&phy13>;
};
};
mdio@0 {
#address-cells = <1>;
#size-cells = <0>;
compatible = "lantiq,xrx200-mdio";
phy0: ethernet-phy@0 {
reg = <0x0>;
compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
};
phy1: ethernet-phy@1 {
reg = <0x1>;
compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
};
phy11: ethernet-phy@11 {
reg = <0x11>;
compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
};
phy13: ethernet-phy@13 {
reg = <0x13>;
compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
};
};
};
&pcie0 {
pcie@0 {
reg = <0 0 0 0 0>;
#interrupt-cells = <1>;
#size-cells = <2>;
#address-cells = <3>;
device_type = "pci";
wifi@0,0 {
compatible = "pci0,0";
reg = <0 0 0 0 0>;
qca,no-eeprom; /* load from ath9k-eeprom-pci-0000:01:00.0.bin */
};
};
};