/dts-v1/; #include "mt7621.dtsi" #include <dt-bindings/input/input.h> / { model = "Buffalo WSR-600DHP"; memory@0 { device_type = "memory"; reg = <0x0 0x4000000>; }; chosen { bootargs = "console=ttyS0,57600"; }; gpio-leds { compatible = "gpio-leds"; power { label = "wsr-600:green:power"; gpios = <&gpio0 12 1>; }; wifi_o { label = "wsr-600:orange:wifi"; gpios = <&gpio1 9 1>; }; diag { label = "wsr-600:orange:diag"; gpios = <&gpio1 10 1>; }; wifi_g { label = "wsr-600:green:wifi"; gpios = <&gpio1 12 1>; }; router_o { label = "wsr-600:orange:router"; gpios = <&gpio1 13 1>; }; router_g { label = "wsr-600:green:router"; gpios = <&gpio1 14 1>; }; internet_o { label = "wsr-600:orange:internet"; gpios = <&gpio1 15 1>; }; internet_g { label = "wsr-600:green:internet"; gpios = <&gpio1 16 1>; }; }; gpio-keys-polled { compatible = "gpio-keys-polled"; #address-cells = <1>; #size-cells = <0>; poll-interval = <20>; power { label = "power"; gpios = <&gpio0 8 1>; linux,code = <KEY_POWER>; }; reset { label = "reset"; gpios = <&gpio0 11 1>; linux,code = <KEY_RESTART>; }; aoss { label = "aoss"; gpios = <&gpio0 18 1>; linux,code = <KEY_WPS_BUTTON>; }; auto { label = "mode"; gpios = <&gpio0 7 0>; linux,code = <BTN_0>; linux,input-type = <EV_SW>; }; ap { label = "ap"; gpios = <&gpio0 6 0>; linux,code = <BTN_0>; linux,input-type = <EV_SW>; }; router { label = "router"; gpios = <&gpio0 10 0>; linux,code = <BTN_0>; linux,input-type = <EV_SW>; }; }; gpio_poweroff { compatible = "gpio-poweroff"; gpios = <&gpio1 11 1>; }; }; &spi0 { status = "okay"; m25p80@0 { #address-cells = <1>; #size-cells = <1>; compatible = "jedec,spi-nor"; reg = <0>; spi-max-frequency = <10000000>; m25p,chunked-io = <32>; partition@0 { label = "u-boot"; reg = <0x0 0x30000>; read-only; }; partition@30000 { label = "u-boot-env"; reg = <0x30000 0x10000>; read-only; }; factory: partition@40000 { label = "factory"; reg = <0x40000 0x10000>; read-only; }; partition@50000 { label = "firmware"; reg = <0x50000 0xfb0000>; }; }; }; &pinctrl { state_default: pinctrl0 { gpio { ralink,group = "i2c", "uart2", "uart3", "rgmii2", "sdhci"; ralink,function = "gpio"; }; }; }; &xhci { status = "disabled"; };