9a61b249c5
fix board patches so that new boards are withing appropriate ifdef
...
Some new board definitions were added within the #ifdef CONFIG_CPU_6338
section while some other were added within #ifdef CONFIG_CPU_6345, fix this
SVN-Revision: 32060
2012-06-05 13:40:41 +00:00
36c99bcc42
fix bisectability of patch 303-spi-board-info.patch
...
It uses spi_register_board_info() from linux/spi/spi.h but does not include it
explicitely.
SVN-Revision: 32058
2012-06-05 13:40:35 +00:00
a4d96aae8d
bump to 3.3.8
...
SVN-Revision: 32055
2012-06-05 06:57:51 +00:00
ffea8eb913
bcm63xx: fix ethernet on 96328avng and 963281TAN
...
The internal switch did not get registered.
SVN-Revision: 32041
2012-06-04 08:35:25 +00:00
3fc76fb781
bcm63xx: build images for 6328 reference boards with various flash sizes
...
Build images for 96328avng and 963281TAN (untested) for three different
flash sizes: 4MB, 8MB, and 16MB.
Known issues:
* Button setup unknown, thus no fail-safe available.
* All other BCM6328 and BCM63XX issues
SVN-Revision: 32004
2012-05-30 10:27:46 +00:00
c454ba3657
bcm63xx: readd accidentially dropped network config for SPW303V
...
SVN-Revision: 32003
2012-05-30 10:27:42 +00:00
ec7786c2ec
bcm63xx: build images for DSL-274XB revision F1
...
Build images for D-Link DSL-274XB revision F1. Flashing
through original web UI as well as CFE works.
Known issues:
* wifi led inverted (on when wifi is off and vice cersa)
* same issues as generic bcm6328 support
SVN-Revision: 31885
2012-05-27 13:22:51 +00:00
8aac009cc9
bcm63xx: add ath9k to atheros wifi profile
...
SVN-Revision: 31884
2012-05-27 13:22:48 +00:00
4aa43122ab
bcm63xx: enable bcm6328 support and required drivers
...
BCM6328 support is in a usable state, with the following issues
* internal switch port not configurable
* external phys not supported
* broadcom wifis will probably not work correctly
* and all other generic bcm63xx issues (so yes, still no ADSL)
SVN-Revision: 31883
2012-05-27 13:22:46 +00:00
e5575fe335
bcm63xx: add support for DSL-274XB rev F1
...
SVN-Revision: 31882
2012-05-27 13:22:43 +00:00
a7a82db16f
bcm63xx: fix port state after network down
...
bcm_enetsw_probe did not properly reset port states, resulting in
connected ports staying disabled after bringing up the interface the
second time.
SVN-Revision: 31881
2012-05-27 13:22:40 +00:00
e19ed52fd1
bcm63xx: add a fixup for ath9k devices
...
SVN-Revision: 31880
2012-05-27 13:22:37 +00:00
e34018cc9e
bcm63xx: add support for the HSSPI controller
...
Add support for the HSSPI controller found on bcm6328 and SPI attached
flash.
SVN-Revision: 31879
2012-05-27 13:22:33 +00:00
099d5eec06
bcm63xx: add preliminary support for bcm6328
...
SVN-Revision: 31878
2012-05-27 13:22:29 +00:00
7dbb132c88
bcm63xx: add flash type detection
...
SVN-Revision: 31877
2012-05-27 13:22:25 +00:00
b0ffeb0021
bcm63xx: pad Speedport W303 V images to 4 MiB
...
Prevents CFE from flashing to the second image offset. Fix up the rootfs
length on first boot else CFE will complain.
SVN-Revision: 31876
2012-05-27 13:22:22 +00:00
226b030e44
bcm63xx: add a default switch configuration for DSL-274XB
...
SVN-Revision: 31874
2012-05-27 13:22:17 +00:00
db1ff5c6fa
bcm63xx: setup network config through uci-defaults
...
SVN-Revision: 31873
2012-05-27 13:22:14 +00:00
72b4fdecc9
bcm63xx: move the board name workaround to /lib/brcm63xx.sh
...
SVN-Revision: 31872
2012-05-27 13:22:11 +00:00
dd37687de0
bcm63xx: use the exact board id as board identification string
...
No need to keep the bcm63xx/ at the start or the chipid info at the end.
SVN-Revision: 31871
2012-05-27 13:22:08 +00:00
2ae5581447
kernel: update linux 3.3 to 3.3.7
...
SVN-Revision: 31848
2012-05-23 21:05:32 +00:00
39994008cb
linux: move certain disabled symbols to the generic configs
...
* CONFIG_ARCH_DMA_ADDR_T_64BIT
* CONFIG_ARCH_HAS_ILOG2_U32
* CONFIG_ARCH_HAS_ILOG2_U64
* CONFIG_ARCH_PHYS_ADDR_T_64BIT
* CONFIG_ARCH_SUPPORTS_MSI
* CONFIG_GENERIC_CPU_DEVICES
* CONFIG_HWMON_DEBUG_CHIP
* CONFIG_I2C_PXA_PCI
* CONFIG_LEDS_GPIO
* CONFIG_MINIX_FS_NATIVE_ENDIAN
* CONFIG_MLX4_CORE
* CONFIG_POWER_SUPPLY
* CONFIG_POWER_SUPPLY_DEBUG
* CONFIG_QUOTACTL
* CONFIG_SDIO_UART
* CONFIG_SENSORS_K10TEMP
* CONFIG_SENSORS_SCH56XX_COMMON
* CONFIG_SENSORS_VIA_CPUTEMP
* CONFIG_SERIO_AMBAKMI
* CONFIG_SERIO_I8042
* CONFIG_SERIO_LIBPS2
* CONFIG_SERIO_PCIPS2
* CONFIG_SERIO_RAW
* CONFIG_SERIO_SERPORT
* CONFIG_SPI_BITBANG
* CONFIG_SPI_GPIO
SVN-Revision: 31737
2012-05-15 10:58:52 +00:00
b472e5d12e
kernel: update linux 3.3 to 3.3.6
...
SVN-Revision: 31709
2012-05-14 09:18:32 +00:00
34018a630f
kernel: update linux 3.3 to 3.3.5
...
SVN-Revision: 31645
2012-05-07 20:11:43 +00:00
b218b15709
bcm63xx: fix a race between PCI bus scan and fallback sprom registration
...
The fallback sprom handler was installed too late, resulting in ssb
failing to get a valid sprom on some devices.
Fixes #11384 .
SVN-Revision: 31638
2012-05-06 21:25:34 +00:00
5d9b44d110
use a define for the poll and debounce interval
...
SVN-Revision: 31550
2012-05-02 15:40:26 +00:00
cbfce53831
kernel: update linux 3.3 to 3.3.4
...
SVN-Revision: 31541
2012-04-30 08:38:11 +00:00
e047cf1899
switch to gpio-keys-polled
...
SVN-Revision: 31491
2012-04-27 16:44:48 +00:00
8a38c62c07
bcm63xx: drop linux 3.2 support
...
SVN-Revision: 31464
2012-04-24 11:49:27 +00:00
77219290e1
bcm63xx: drop linux 3.0 support
...
SVN-Revision: 31463
2012-04-24 11:49:24 +00:00
49de6c1714
bcm63xx: switch kernel to 3.3
...
SVN-Revision: 31462
2012-04-24 11:49:19 +00:00
f7df1eafc4
bcm63xx: enable bcm6368 for linux 3.3 and build images
...
Only build bcm6368 images when building for linux 3.3.
SVN-Revision: 31133
2012-03-28 20:42:37 +00:00
c7ae2fccb6
bcm63xx: add initial support for bcm6368 boards
...
SVN-Revision: 31132
2012-03-28 20:42:34 +00:00
68f268a5eb
bcm63xx: add driver for the internal hw trng on bcm6368
...
SVN-Revision: 31131
2012-03-28 20:42:30 +00:00
78fb818f7c
bcm63xx: replace SPI driver with latest upstream version
...
SVN-Revision: 31130
2012-03-28 20:42:25 +00:00
a2adca6ee9
bcm63xx: add ethernet support for bcm6368
...
Add basic support for the internal ethernet switch on bcm6368. It behaves
as a dumb switch for now, but allows basic connectivity.
Also drop the ethernet patch for bcm6345 for now, it needs rework.
SVN-Revision: 31129
2012-03-28 20:42:20 +00:00
0876972850
bcm63xx: add missing bits from extirq support
...
Add missing external IRQ code parts for older chips in the new code.
SVN-Revision: 31128
2012-03-28 20:42:15 +00:00
44d546290a
bcm63xx: reorder patches
...
Reorder patches for a clearer distinction between the purposes of
the different patches.
SVN-Revision: 31127
2012-03-28 20:42:09 +00:00
db6e326c56
targets: replace madwifi in profiles with ath5k, madwifi is unmaintained
...
SVN-Revision: 31015
2012-03-19 09:58:13 +00:00
07486c4d96
remove udc patch since it is unused
...
SVN-Revision: 30920
2012-03-13 14:06:44 +00:00
1029786936
remove 3.1 support
...
SVN-Revision: 30823
2012-03-05 16:50:42 +00:00
75b5f4a6b4
rename 96348GW-1{0,1}-gen to 96348GW-1{0,1}-generic
...
SVN-Revision: 30822
2012-03-05 14:49:34 +00:00
c327915156
generate generic images for BCM96358VW and BCM96358VW2 ( #10666 )
...
SVN-Revision: 30821
2012-03-05 14:49:31 +00:00
ca1e59660e
wire bcm96348gw-10 reset button ( #10854 )
...
SVN-Revision: 30820
2012-03-05 14:23:45 +00:00
631a035a76
Merge branch 'bcm63xx'
...
SVN-Revision: 30819
2012-03-05 13:29:54 +00:00
778e5d4fa5
brcm63xx: add support for linux 3.3
...
SVN-Revision: 30027
2012-02-04 10:17:27 +00:00
e67f4477bb
kernel: update linux 3.0 to 3.0.18
...
SVN-Revision: 29965
2012-01-31 09:43:53 +00:00
882eddbf92
build 96348R images
...
SVN-Revision: 29960
2012-01-30 21:12:32 +00:00
0700644b16
remove support for 2.6.39
...
SVN-Revision: 29959
2012-01-30 21:12:28 +00:00
038fc8eac3
bump to 3.0.17
...
SVN-Revision: 29958
2012-01-30 21:12:25 +00:00
Florian Fainelli
John Crispin
Jonas Gorski
Gabor Juhos
Felix Fietkau