2 Commits (e1debc557cc27061d8bb02b04e04e0b606678650)

Author	SHA1	Message	Date
Koen Vandeputte	e2aa0c3f8b	kernel: bump 4.14 to 4.14.41 ... Refreshed all patches Dropped upstreamed patches: 522-PCI-aardvark-fix-logic-in-PCI-configuration-read-write-functions.patch 523-PCI-aardvark-set-PIO_ADDR_LS-correctly-in-advk_pcie_rd_conf.patch 525-PCI-aardvark-use-isr1-instead-of-isr0-interrupt-in-legacy-irq-mode.patch 527-PCI-aardvark-fix-PCIe-max-read-request-size-setting.patch updated patches: 524-PCI-aardvark-set-host-and-device-to-the-same-MAX-payload-size.patch 030-USB-serial-option-fix-dwm-158-3g-modem-interface.patch Added new ARM64 symbol: CONFIG_ARM64_ERRATUM_1024718 Compile-tested on: cns3xxx, imx6, mvebu (arm64), x86_64 Runtime-tested on: cns3xxx, imx6, x86_64 Signed-off-by: Koen Vandeputte <koen.vandeputte@ncentric.com>	2018-05-18 09:10:46 +02:00
Roman Yeryomin	ce93b05bf1	gemini: fix hard disk boot on D-Link devices ... Since the D-Link devices boot from hard disk we need to add the following changes to Gemini: - Supply a bootarg in the device tree so we can boot from the right partition (/dev/sda4 on DNS-313) - Disable forced command line in config so the kernel picks up the right bootargs from the device tree - Enable EXT4 in the config as this is used for rootfs else we get nowhere, we cannot load this as a module because, well, it is supposed to be loaded from the root partition (chicken and egg problem). - Enable jbd2 and mbcache (needed by ext4) Also clean out the premature attempts to dynamically modify the command line in the Image makefile: we should pass this with the device tree bootargs instead, it works much better. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> Signed-off-by: Roman Yeryomin <roman@advem.lv>	2018-05-05 06:57:00 +02:00