513e8c583f
Several small fixes for ar8216 driver (patch by Jonas Gorski)
...
* Create defines for some magic values/masks.
* Change vlan_id to u16, to allow VIDs > 255.
* Add a range check to set_pvid as it isn't a VID, but the index
in the vlan table.
* Set the max VID to 4094, since 4095 is a reserved value and
should not be used.
* In mangle_rx replace the provided VID with the VID of the table
entry of the port, not the index of the table.
* In hw_apply, remove a redundant emptyness check (was already
checked several lines above).
* In no vlan mode do not set the ingress mode to secure, as there
are no vlan table entries, but to use the port's destination
masks. Otherwise the switch won't forward anything.
* In read_status tell that the phy is up (taken from the rtl8306
driver).
SVN-Revision: 20083
2010-03-09 14:35:41 +00:00
f1509eaf8c
kernel: add driver for the RTL8366RB switch
...
Thanks to Andrew Tarabaras.
SVN-Revision: 19837
2010-02-24 13:39:02 +00:00
e251cd15c9
kernel: fix typos in the AR8216 header file
...
SVN-Revision: 19834
2010-02-24 13:38:48 +00:00
c253898e89
rtl8366_smi: sanitize gpio values to a 0/1 boolean
...
SVN-Revision: 19402
2010-01-30 15:25:12 +00:00
6bfdc7c998
rtl8366s: reset the chip early, this allows ethernet to work as soon as possible
...
SVN-Revision: 19355
2010-01-27 21:01:48 +00:00
49c4df5487
rtl8366: make it available on all platforms
...
SVN-Revision: 19329
2010-01-25 15:13:38 +00:00
2bff4bf4e5
rtl8306: manage the wan port as a separate phy device with proper link status reading and autonegotiation - the genphy driver does not handle it properly
...
SVN-Revision: 18709
2009-12-09 03:25:33 +00:00
ddc2e2270b
ar71xx: make the rtl8306 switch attach to eth0 instead of eth1 on the wrt160nl, fixes wan port detection ( #6309 )
...
SVN-Revision: 18699
2009-12-08 14:06:18 +00:00
df35ee622f
fix link status detection in various switch drivers
...
SVN-Revision: 18698
2009-12-08 14:06:09 +00:00
30e635c55b
move the updated version (for 2.6.30+) of ar8216/mvswitch to the generic files directory and remove patches for older kernel versions (no longer in use)
...
SVN-Revision: 17594
2009-09-16 12:24:46 +00:00
6e28b28c5e
add a driver for rtl8306 switches
...
SVN-Revision: 17248
2009-08-14 00:52:17 +00:00
3e7d58574f
ar8216: rename the vlan attribute to enable_vlan to keep it consistent with other drivers
...
SVN-Revision: 16770
2009-07-11 01:21:01 +00:00
3455f00d7a
ar8216: fix transmission of large frames by setting the switch mtu
...
SVN-Revision: 16629
2009-06-29 21:54:16 +00:00
c1918c778c
ar8216: add delay for page switching to work around register setting corruption. use packet mangling to fix up the vlan for incoming packets (workaround for hardware bug, which renders normal 802.1q support unusable)
...
SVN-Revision: 16442
2009-06-14 03:32:01 +00:00
4e12c9d210
fix a crash in ip175c attribute enumeration
...
SVN-Revision: 15506
2009-04-30 13:57:22 +00:00
a523450678
Add a driver for Atheros AR8216 switches Thanks to Vertical Communications, Inc. for providing access to the documentation
...
SVN-Revision: 15482
2009-04-29 13:02:41 +00:00
8ec2ad91ad
swconfig: add a generic switch reset call
...
SVN-Revision: 15470
2009-04-28 19:16:17 +00:00
3fce73ce46
clean up the ip175c driver some more, add support for setting the pvid and fix querying the phy status
...
SVN-Revision: 15308
2009-04-20 21:26:44 +00:00
f6f55bae7d
swconfig: add a generic method for setting the port primary vlan id (used for transparently fixing up pvid for untagged port when setting vlan ports)
...
SVN-Revision: 15307
2009-04-20 21:26:39 +00:00
4320a28228
add IC+ IP175C driver (based on Patrick Horn's driver, see #4050 )
...
SVN-Revision: 15305
2009-04-20 18:57:55 +00:00
787e9fcf93
swconfig: treat struct switch_attr as constant
...
SVN-Revision: 15302
2009-04-20 18:57:36 +00:00
cd80e16a80
swconfig: remove old debugging stuff
...
SVN-Revision: 15301
2009-04-20 18:57:30 +00:00
1929c7511c
mvswitch: re-enable header mode
...
SVN-Revision: 15186
2009-04-10 11:33:49 +00:00
bfa8064ccd
atheros: in later kernels, vlan 0 no longer works as expected, switch to (1,2) instead of (0,1) for lan/wan
...
SVN-Revision: 14981
2009-03-22 20:19:23 +00:00
f972eb41b5
mvswitch,adm6996: use phy fixups instead of a nonstandard patch for hardware detection
...
SVN-Revision: 14977
2009-03-22 20:18:36 +00:00
d1b986bd54
improve routing/nat performance for devices using the marvell 88e6060 switch
...
SVN-Revision: 13060
2008-10-28 17:54:22 +00:00
1e570a9288
change the way ./files* and the generic kernel files are applied. ./files now applies to *ALL* kernel versions, and is copied along with ./files-* - this gets rid of quite a bit of redundancy in the extra kernel drivers.
...
SVN-Revision: 13010
2008-10-18 21:43:30 +00:00
c7150f281c
add missing defines for mvswitch
...
SVN-Revision: 11895
2008-07-21 18:12:38 +00:00
3ad51a1c33
some more mvswitch fixes: - initialize the vlan destination map properly - workaround for moving node bug: clear the ATU database on every PHY poll
...
SVN-Revision: 11881
2008-07-19 23:09:56 +00:00
87e673487a
add extra safety for the packet mangling in the mvswitch driver
...
SVN-Revision: 11880
2008-07-19 23:09:43 +00:00
b014357704
set marvell switch ATU ageing time to minimum instead of maximum - hopefully fixes some fonera 2.0 ethernet issues
...
SVN-Revision: 11410
2008-06-09 10:31:46 +00:00
9e0ee80132
enable a different pseudo-vlan mode in the marvell switch (uses a proprietary header instead of a proprietary trailer) - fixes some mtu issues
...
SVN-Revision: 10975
2008-04-29 12:55:44 +00:00
c3fcb26d47
allow bigger packets in the marvell switch (does not fix the mtu problems yet)
...
SVN-Revision: 10970
2008-04-28 21:59:06 +00:00
86bbc820d5
fix vlan mapping for cpu port on the marvell switch
...
SVN-Revision: 10934
2008-04-24 01:09:47 +00:00
69999abeda
clear VLANTunnel bit on the marvell switch ports - should help with some bridging issues
...
SVN-Revision: 10931
2008-04-23 16:28:05 +00:00
11d94ce083
Add support for the ultra-crappy Marvell 88E6060, which is used in Fonera+ and the upcoming Fonera 2.0
...
SVN-Revision: 10876
2008-04-20 08:29:01 +00:00
a323a7bf2a
Add stub driver for ADM6996F switches (configured through MII) The driver currently uses a hardcoded VLAN mapping and has no configuration yet Tested on Accton MR3202a
...
SVN-Revision: 10869
2008-04-20 02:53:04 +00:00
Felix Fietkau
Gabor Juhos