d8f1fa1e38
switch: ROBO Switch Gigabit MII Support
...
I wrote this patch some time ago because I had a need for one of the
Gigabit ports (Linksys E3000) to be forced to 100FD. This is based
on the robocfg sources included w/ the RT-N16 sources from ASUS.
Since work is progressing on a BGMAC driver that could be included in
OpenWRT, this may be useful to someone else.
In testing, forcing the speed to 10/100 or 1000 worked fine; however,
when trying to force full-duplex mode, the result was always
half-duplex. I was not able to isolate the source of the problem
(this patch, driver or H/W limitation). The only way I could get it
to work was to set the port to Auto, but then only advertise 100FD
(not included in this patch).
I have a modified version of the robocfg package as well, I'd have to
clean it up a little first (remove the full-duplex hack) before
submitting it if there is interest.
Signed-off-by: Nathan Hintz <nlhintz@hotmail.com>
SVN-Revision: 34992
2013-01-03 01:58:01 +00:00
63ec34612c
switch: improve error messages
...
This is in part based on a patch send by Nathan Hintz <nlhintz@hotmail.com>
SVN-Revision: 34991
2013-01-03 01:57:19 +00:00
25afeba608
brcm47xx: add a new version of the nvram rewrite patch
...
This is the version like it was send for mainline inclusion.
SVN-Revision: 34988
2013-01-03 01:53:30 +00:00
da94d4ac29
switch: warn if ndo_do_ioctl is not implemented in the Ethernet driver
...
SVN-Revision: 33506
2012-09-22 12:29:23 +00:00
bf0974e8da
switch: improve error message
...
SVN-Revision: 33464
2012-09-19 10:57:38 +00:00
40f139b53b
switch: clean up robo switch driver
...
* remove use_et, all supported drivers are using mii ioctls
* remove robo.phy_addr, phy_addr was always set to ROBO_PHY_ADDR.
* remove support for old kernel versions
* do_ioctl is allways called with buff == NULL
* use if_mii
SVN-Revision: 33002
2012-08-05 13:10:43 +00:00
0758996824
brcm47xx: use libgpio instaed of implementing the gpio interface ourself.
...
SVN-Revision: 32992
2012-08-04 19:46:25 +00:00
654f9c879f
switch: the hardware must be up while configuring Since the removal of the interface coldplug hack the timing changed in such a way that eth0 is not up during switch setup, leading to an inaccesible device. Bring up the switch interface before configuring it to mitigate the problem.
...
SVN-Revision: 30937
2012-03-13 21:15:41 +00:00
b9da4dcb6b
switch: fix some memory leaks in switch_parse_vlan()
...
SVN-Revision: 29936
2012-01-28 13:52:37 +00:00
b220442c75
switch: update for brcm47xx target
...
* remove suport for 2.4 kernel
* add support for bcma bus
SVN-Revision: 27904
2011-08-04 20:07:58 +00:00
640927dde3
switch: fix switch-robo device reference counting
...
Fix incorrect device reference counting by switch-robo.
Signed-off-by: George Kashperko <george@znau.edu.ua>
SVN-Revision: 25619
2011-02-20 17:24:15 +00:00
e31542241c
remove whitespaces in kmod-switch sources
...
SVN-Revision: 22320
2010-07-20 22:25:04 +00:00
2d86ea7bf3
massive: replace occurences of .$(LINUX_KMOD_SUFFIX) with .ko after r21950
...
SVN-Revision: 22145
2010-07-12 14:06:13 +00:00
543d870e82
remove linux 2.4 support from several packages
...
SVN-Revision: 21954
2010-06-26 20:43:41 +00:00
501e154d03
switch: explicitely clear port mappings in unsused vlans ( #7082 )
...
SVN-Revision: 20717
2010-04-05 13:51:26 +00:00
2d100861a4
switch: suppress boot error message on 2.4
...
SVN-Revision: 19922
2010-03-01 01:12:57 +00:00
96e4312e7e
switch: eliminate the asterisk from the switch port configuration and set it automatically on the first vlan, this aligns the broadcom vlan config with the swconfig format
...
SVN-Revision: 19909
2010-02-28 16:40:06 +00:00
f4edda27af
switch: do not include linux/autoconf.h ( #6513 )
...
SVN-Revision: 19903
2010-02-28 12:57:57 +00:00
194f32bc26
change switch config to swconfig style format to remain consistent accross platforms
...
SVN-Revision: 18425
2009-11-15 18:43:46 +00:00
5a13cc0726
fix breakage on wl500gp after r18214, thanks sn9 ( #6084 )
...
SVN-Revision: 18289
2009-11-03 20:35:37 +00:00
2d57b56bce
make etehrent work on wrt350n, thx sn9
...
SVN-Revision: 18214
2009-10-29 21:26:36 +00:00
8673372e20
add patches for kernel 2.6.31
...
This is completly untested. Only a compile tests with the default config was done!
SVN-Revision: 17734
2009-09-26 11:48:48 +00:00
369db35a29
fix oops in switch-robo on brcm63xx, thanks to Daniel Dickinson ( #5053 )
...
SVN-Revision: 15611
2009-05-05 06:32:45 +00:00
9051239daf
prevent kmod-switch from accessing nvram on brcm63xx ( #5035 )
...
SVN-Revision: 15555
2009-05-02 10:01:09 +00:00
210254c279
fix nvram_get checking on non-WGT634U ( #4975 )
...
SVN-Revision: 15319
2009-04-21 09:25:51 +00:00
6f80c9cc7c
fix strange LED behavior with Netgear WGT634U ( #3552 )
...
SVN-Revision: 15290
2009-04-20 10:27:46 +00:00
34939cad39
get rid of $Id$ - it has never helped us and it has broken too many patches ;)
...
SVN-Revision: 15242
2009-04-17 14:09:46 +00:00
04909ca614
allow kmod-switch to be used on brcm63xx ( #4599 )
...
SVN-Revision: 14825
2009-03-09 21:57:11 +00:00
529e87f6c5
switch: remove message about BFL_ENETADM not being set on systems with a roboswitch
...
SVN-Revision: 13100
2008-11-02 23:14:16 +00:00
40990382e5
(4/6) bcm57xx: switch-core.c/switch-robo.c check for port already registered
...
This patch prevents switch-robo.c from attempting robo_probe on a port
that is already registered. robo_probe will adjust kernel reference counts
if it detects a switch on the port. If this patch wasn't applied, the
wrt350n would hang on reboot, waiting for the network driver reference count
to reach zero indefinitely.
Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>
SVN-Revision: 11469
2008-06-15 11:10:27 +00:00
f027ecb2cf
Stopgap compilation fixes for diag and switch under 2.6.25
...
SVN-Revision: 11231
2008-05-20 22:33:45 +00:00
72d40dec08
Allow package/switch to compile against 2.6.25
...
SVN-Revision: 11138
2008-05-14 15:03:05 +00:00
6a2a1e251b
Check the return values of kmalloc()
...
SVN-Revision: 10599
2008-03-13 15:22:46 +00:00
d65241e13b
fix switch-robo.c compile errors on linux 2.4
...
SVN-Revision: 10539
2008-03-01 15:34:17 +00:00
a9cddc69ec
Fix the roboswitch code for the WRT350N
...
SVN-Revision: 10531
2008-02-27 22:35:41 +00:00
faa14263f5
ssb: Make the GPIO API reentrancy safe.
...
SVN-Revision: 10496
2008-02-19 15:22:17 +00:00
d9e54d1e0b
export switch-core.h to $(STAGING_DIR)
...
SVN-Revision: 10138
2008-01-06 19:28:26 +00:00
e3ecefbd23
fix adm switch misdetection, which led to bogus button events that caused the system to shut down
...
SVN-Revision: 9555
2007-11-16 03:11:09 +00:00
a9d683ca91
major target cleanup. it is now possible to have subtargets that can override many target settings, including arch - merge adm5120, adm5120eb. target profiles still need to be adapted for subtargets
...
SVN-Revision: 8694
2007-09-08 19:55:42 +00:00
e3dc76af1b
fix board name for nvram and switch packages on brcm-2.4 after [8653]
...
SVN-Revision: 8664
2007-09-07 12:54:24 +00:00
34bb4638e7
move package description to a separate definition, remove it when DESCRIPTION=TITLE
...
SVN-Revision: 8659
2007-09-07 08:34:51 +00:00
56231056ea
strip the kernel version suffix from target directories, except for brcm-2.4 (the -2.4 will be included in the board name here). CONFIG_LINUX_<ver>_<board> becomes CONFIG_TARGET_<board>, same for profiles.
...
SVN-Revision: 8653
2007-09-06 16:27:37 +00:00
be0de75a3e
package Makefile cleanup: remove uneeded vars
...
SVN-Revision: 8587
2007-09-03 08:20:36 +00:00
02cd6d278f
use a default VERSION field for kmod packages
...
SVN-Revision: 8575
2007-09-02 16:39:27 +00:00
80840457a5
fix kmod-switch compile on brcm-2.4 ( #1461 )
...
SVN-Revision: 6565
2007-03-14 13:42:21 +00:00
dcfbd5f656
fix up remaining parts for the brcm47xx-2.6 port (tested on wgt634u), nuke the old brcm-2.6 port, close #1312 , #1451
...
SVN-Revision: 6564
2007-03-14 03:37:40 +00:00
bf622ab0ae
add diag and switch support for brcm47xx-2.6
...
SVN-Revision: 6562
2007-03-14 01:19:24 +00:00
c606df6563
cleanup, nuke obsolete 'Kernel drivers' category, convert remaining kmod packages to KernelPackage interface
...
SVN-Revision: 6136
2007-01-20 02:01:53 +00:00
dd03b56357
fix memory leak in switch drivers (patch from #1132 )
...
SVN-Revision: 6011
2007-01-07 14:59:43 +00:00
abd458dae6
Fix the counters bug ( #983 )
...
SVN-Revision: 5910
2006-12-27 19:35:13 +00:00
Hauke Mehrtens
Jo-Philipp Wich
Florian Fainelli
Claudio Mignanti
Felix Fietkau
Nicolas Thill
John Crispin
Peter Denison
Michael Büsch