5cf0db54c6
Package ip6t_limit and ip6t_frag for 2.4 kernels ( #3760 )
...
SVN-Revision: 12276
2008-08-11 06:38:48 +00:00
9b2e1bdd8d
fix Dell TrueMobile 2300 v1/v2 detection and network configuration ( closes #2788 )
...
SVN-Revision: 11935
2008-07-26 16:10:44 +00:00
4e9e2cba40
fix sierra patches
...
SVN-Revision: 11909
2008-07-22 15:16:43 +00:00
8894411b60
This is the Linksys-ported driver from WRT54G3G-ST_v2.00.9_US.tgz, re-based against 2.4.35 and repaired for obvious breakage (didn't use its device table, etc.).
...
Changes from Linksys tree:
- Remove 'vendor' and 'product' parameters; these aren't used in the
mainstream driver and seem to only have served to break it.
- Remove bogus 'sierra_device_ids' table, used with above.
- Changed references to 'sierra_device_ids' back to id_table
- Changed non-standard CONFIG_USB_SERIAL_SIERRA_3G (line 886) to
current module standard CONFIG_USB_SERIAL_SIERRAWIRELESS
- Added #include to enable pl2303 hack to remain until I can figure
out if it's still necessary.
Signed-off-by: RB <aoz.syn@gmail.com>
SVN-Revision: 11899
2008-07-21 20:40:14 +00:00
1a47f8142d
This series of patches closes the support gap on one of the explicitly supported platforms (WRT54G3G) by adding direct support for the Sierra Wireless 3G modems. Signed-off-by: RB <aoz.syn@gmail.com>
...
SVN-Revision: 11898
2008-07-21 20:36:16 +00:00
20937ce81a
(5/6) bcm57xx: bcm4785 incomplete reboot
...
I noticed my wrt350n would not reliably reboot after entering
the reboot command. I found this code in the source for the
wrt600n. It corrects the problem, and the wrt350n reboots
reliably now.
Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>
SVN-Revision: 11470
2008-06-15 11:10:43 +00:00
9621d872ca
(3/6) bcm57xx: preinit
...
This patch allows the bcm57xx module to work correctly with failsafe mode.
insmod doesn't return an error when a module loads but doesn't detect a switch.
I added the check_module function to load the module, then make sure
it doesn't just exit immediately. This allows preinit to only attempt to
load the bcm57xx module when switch-robo and switch-adm dont detect a switch.
The activate_gpio parameter to bcm57xx simply instructs the module to attempt
to activate the switch via gpio before probing for the switch.
Tested on wrt350n.
Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>
SVN-Revision: 11468
2008-06-15 11:10:13 +00:00
f9ad520e37
(2/6) bcm57xx: netconfig
...
Update the netconfig script to support boardtype 0x478. I've tested this
on the wrt350n, hopefully it will match the 600n as well.
Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>
SVN-Revision: 11467
2008-06-15 11:09:49 +00:00
473d5705bd
Include missing part of r11275. Fix fw_argX from CFE
...
SVN-Revision: 11340
2008-06-03 19:29:53 +00:00
c9f6d43927
Don't nuke fw_argX from CFE - Thanks jhansen
...
SVN-Revision: 11275
2008-05-27 15:01:07 +00:00
8932b397b8
refresh kernel patches
...
SVN-Revision: 11214
2008-05-19 13:45:06 +00:00
0d25337129
This patch lets netconfig support the asus wl-500w. Signed-off-by: Ben Pfountz <netprince@vt.edu>
...
SVN-Revision: 11070
2008-05-08 01:30:14 +00:00
0ed1824fa1
Add a generic Broadcom USB profile.
...
SVN-Revision: 10695
2008-03-31 08:05:30 +00:00
a2ccc5b790
Change WL500gP profile to use uhci-iv ( #1589 )
...
SVN-Revision: 10694
2008-03-31 08:05:13 +00:00
c15de3860c
Add support for the WL-500gP v2
...
SVN-Revision: 10693
2008-03-31 08:04:56 +00:00
85a1127f2d
add wrt350n image file
...
SVN-Revision: 10205
2008-01-16 03:39:59 +00:00
a4ca693c7e
Add back Sitecom WL-105b support
...
SVN-Revision: 10142
2008-01-08 14:27:48 +00:00
178721f76b
update brcm-2.4 to 2.4.35.4, integrate new broadcom system code, update broadcom-wl to a contributed version (v4.150.10.5) - no bcm57xx support yet, will follow shortly
...
SVN-Revision: 10137
2008-01-06 19:28:07 +00:00
f031f4c7dc
bump version numbers of Linksys images
...
SVN-Revision: 10097
2008-01-03 21:28:56 +00:00
dc36fccfdc
Add bcm5354 patch from #2754
...
SVN-Revision: 9684
2007-12-09 15:51:45 +00:00
bf0dd24627
create broadcom initramfs images and move the lzma decompressor area a bit further
...
SVN-Revision: 9556
2007-11-16 03:11:17 +00:00
1bca0cc517
make the image filenames a bit shorter
...
SVN-Revision: 9533
2007-11-10 23:08:11 +00:00
fe6294e21c
update wrt54g3g pattern version, add wrt54g3g-em pattern ( #2663 )
...
SVN-Revision: 9523
2007-11-10 15:45:38 +00:00
fcdf364d10
fix missing CONFIG_USB_BLUETOOTH issue
...
SVN-Revision: 9494
2007-11-03 22:32:54 +00:00
438dfe5c6f
get rid of per-profile base-files
...
SVN-Revision: 9069
2007-09-29 14:27:54 +00:00
a3c80a1e6e
fix vlan configuration on Dell TrueMobile 2300
...
SVN-Revision: 9015
2007-09-25 08:34:30 +00:00
1e758b6e05
refresh brcm-2.4 kconfig
...
SVN-Revision: 8949
2007-09-22 15:06:15 +00:00
236d7e62ca
clean up jffs2 config options
...
SVN-Revision: 8848
2007-09-19 20:58:16 +00:00
1d7dc11649
Add preliminary support for sysupgrade on brcm
...
SVN-Revision: 8718
2007-09-09 19:18:02 +00:00
87a88cebc7
adapt profiles for subtarget changes
...
SVN-Revision: 8695
2007-09-08 20:04:43 +00:00
a9d683ca91
major target cleanup. it is now possible to have subtargets that can override many target settings, including arch - merge adm5120, adm5120eb. target profiles still need to be adapted for subtargets
...
SVN-Revision: 8694
2007-09-08 19:55:42 +00:00
75f1024d48
fix pci init for brcm-2.4 with atheros wifi cards
...
SVN-Revision: 8690
2007-09-08 13:39:34 +00:00
22742b2d7e
remove some obsolete files
...
SVN-Revision: 8654
2007-09-06 16:40:36 +00:00
56231056ea
strip the kernel version suffix from target directories, except for brcm-2.4 (the -2.4 will be included in the board name here). CONFIG_LINUX_<ver>_<board> becomes CONFIG_TARGET_<board>, same for profiles.
...
SVN-Revision: 8653
2007-09-06 16:27:37 +00:00
7ab328b133
workaround for timer glitch on some boards
...
SVN-Revision: 8483
2007-08-25 13:18:58 +00:00
c6e6780624
fix wan configuration on wr850g v2/v3
...
SVN-Revision: 8482
2007-08-25 12:27:01 +00:00
be8bb854f9
Add usb-keyspan modules ( #2229 )
...
SVN-Revision: 8450
2007-08-21 09:42:25 +00:00
c6bc77ea36
build system cleanup/restructuring as described in http://lists.openwrt.org/pipermail/openwrt-devel/2007-August/001159.html
...
SVN-Revision: 8362
2007-08-07 00:04:25 +00:00
114b9a8fb6
add failsafe support for atheros-2.6 ( #1501 ) - only works with ar5315+ at the moment
...
SVN-Revision: 7870
2007-07-04 04:35:44 +00:00
5e7cb507cd
move parts of the failsafe code to the generic base-files - will be used on atheros as well as soon as i've added support for it
...
SVN-Revision: 7810
2007-06-30 21:09:02 +00:00
7e4f2dbf66
make the broadcom firmware image code more sane and also fix jffs2-256k related bugs ( #1888 )
...
SVN-Revision: 7731
2007-06-25 15:36:31 +00:00
8c41e51e92
fix failsafe on broadcom, send netlink events in diag when running linux 2.6
...
SVN-Revision: 7722
2007-06-25 08:32:25 +00:00
1c7ab50199
Really apply the esfq patch
...
SVN-Revision: 7623
2007-06-13 19:12:44 +00:00
027b61b790
Resync brcm-2.4 kernel config and enable syncookies ( #1876 )
...
SVN-Revision: 7622
2007-06-13 18:50:51 +00:00
f9699632f1
enable image generation for the WRT150N
...
SVN-Revision: 7486
2007-06-04 09:26:40 +00:00
84b235140c
fix pcmcia/pccard build defaults
...
SVN-Revision: 7275
2007-05-19 16:16:48 +00:00
63300d3d91
Fix broadcom squashfs images:
...
We switched over to appending the jffs2 eof mark to the squashfs images,
but since the squashfs is not always aligned to eraseblocksize, the eof
mark landed in the wrong place. This commit adds an extra flag to the
trx utility that can append extra data to a partition with alignment.
This is used to place the jffs2 eof mark at the right offset.
SVN-Revision: 7253
2007-05-15 18:41:48 +00:00
3fda1fbf87
cleanup the broadcom preinit.arch
...
SVN-Revision: 7176
2007-05-10 16:29:15 +00:00
e1e6f5489f
minor cleanup
...
SVN-Revision: 7174
2007-05-10 14:43:52 +00:00
4a41439c46
unified preinit environment
...
SVN-Revision: 7173
2007-05-10 14:37:47 +00:00
Florian Fainelli
Gabor Juhos
Travis Kemen
Felix Fietkau
Peter Denison
Andy Boyett
Imre Kaloz
Jens Muecke
Nicolas Thill
Mike Baker