mirror of https://github.com/hak5/openwrt.git
ramips: add support for netis WF2770
netis WF2770 is a 2.4/5GHz band AC750 router, based on MediaTek MT7620A. Specifications: - SoC: MT7620A - RAM: DDR2 64MB - Flash: SPI NOR 16MB - WiFi: - 2.4GHz: SoC internal - 5GHz: MT7610EN - Ethernet: 5x 10/100/1000Mbps - Switch: MT7530BU - UART: - J2: 3.3V, RX, TX, GND (3.3V is the square pad) / 57600 8N1 MAC addresses in factory partition: 0x0004: LAN, WiFi 2.4GHz (label_mac-6) 0x0028: not used (label_mac-1) 0x002e: WAN (label_mac) 0x8004: WiFi 5GHz (label_mac+2) Installation via web interface: 1. Flash **initramfs** image through the stock web interface. 2. Boot into OpenWrt and perform sysupgrade with sysupgrade image. Revert to stock firmware: 1. Perform sysupgrade with stock image. Reviewed-by: Pawel Dembicki <paweldembicki@gmail.com> Signed-off-by: Sungbo Eo <mans0n@gorani.run>master
Sungbo Eo
Adrian Schmutzler
parent
46674723e1
commit
a4e9c8f14b
|
|
@ -0,0 +1,161 @@
|
|||
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
|
||||
/dts-v1/;
|
||||
|
||||
#include "mt7620a.dtsi"
|
||||
|
||||
#include <dt-bindings/gpio/gpio.h>
|
||||
#include <dt-bindings/input/input.h>
|
||||
|
||||
/ {
|
||||
compatible = "netis,wf2770", "ralink,mt7620a-soc";
|
||||
model = "NETIS WF2770";
|
||||
|
||||
leds {
|
||||
compatible = "gpio-leds";
|
||||
|
||||
wlan {
|
||||
label = "wf2770:blue:wlan";
|
||||
gpios = <&gpio0 14 GPIO_ACTIVE_LOW>;
|
||||
linux,default-trigger = "phy0tpt";
|
||||
};
|
||||
};
|
||||
|
||||
keys {
|
||||
compatible = "gpio-keys";
|
||||
|
||||
reset {
|
||||
label = "reset";
|
||||
gpios = <&gpio0 1 GPIO_ACTIVE_LOW>;
|
||||
linux,code = <KEY_RESTART>;
|
||||
};
|
||||
|
||||
wps {
|
||||
label = "wps";
|
||||
gpios = <&gpio0 2 GPIO_ACTIVE_LOW>;
|
||||
linux,code = <KEY_WPS_BUTTON>;
|
||||
};
|
||||
|
||||
rfkill {
|
||||
label = "rfkill";
|
||||
gpios = <&gpio0 7 GPIO_ACTIVE_LOW>;
|
||||
linux,code = <KEY_RFKILL>;
|
||||
};
|
||||
|
||||
led-toggle {
|
||||
label = "led-toggle";
|
||||
gpios = <&gpio0 11 GPIO_ACTIVE_LOW>;
|
||||
linux,code = <KEY_LIGHTS_TOGGLE>;
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&spi0 {
|
||||
status = "okay";
|
||||
|
||||
flash@0 {
|
||||
compatible = "jedec,spi-nor";
|
||||
reg = <0>;
|
||||
spi-max-frequency = <50000000>;
|
||||
|
||||
partitions {
|
||||
compatible = "fixed-partitions";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
partition@0 {
|
||||
label = "u-boot";
|
||||
reg = <0x0 0x30000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@30000 {
|
||||
label = "config";
|
||||
reg = <0x30000 0x10000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
factory: partition@40000 {
|
||||
label = "factory";
|
||||
reg = <0x40000 0x10000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@50000 {
|
||||
compatible = "denx,uimage";
|
||||
label = "firmware";
|
||||
reg = <0x50000 0xfb0000>;
|
||||
};
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&state_default {
|
||||
gpio {
|
||||
groups = "i2c", "uartf";
|
||||
function = "gpio";
|
||||
};
|
||||
};
|
||||
|
||||
ðernet {
|
||||
pinctrl-names = "default";
|
||||
pinctrl-0 = <&rgmii1_pins &mdio_pins>;
|
||||
|
||||
mtd-mac-address = <&factory 0x4>;
|
||||
|
||||
port@5 {
|
||||
status = "okay";
|
||||
mediatek,fixed-link = <1000 1 1 1>;
|
||||
phy-mode = "rgmii";
|
||||
};
|
||||
|
||||
mdio-bus {
|
||||
status = "okay";
|
||||
|
||||
ethernet-phy@0 {
|
||||
reg = <0>;
|
||||
phy-mode = "rgmii";
|
||||
};
|
||||
|
||||
ethernet-phy@1 {
|
||||
reg = <1>;
|
||||
phy-mode = "rgmii";
|
||||
};
|
||||
|
||||
ethernet-phy@2 {
|
||||
reg = <2>;
|
||||
phy-mode = "rgmii";
|
||||
};
|
||||
|
||||
ethernet-phy@3 {
|
||||
reg = <3>;
|
||||
phy-mode = "rgmii";
|
||||
};
|
||||
|
||||
ethernet-phy@4 {
|
||||
reg = <4>;
|
||||
phy-mode = "rgmii";
|
||||
};
|
||||
|
||||
ethernet-phy@1f {
|
||||
reg = <0x1f>;
|
||||
phy-mode = "rgmii";
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&pcie {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&pcie0 {
|
||||
wifi@0,0 {
|
||||
compatible = "mediatek,mt76";
|
||||
reg = <0x0000 0 0 0 0>;
|
||||
mediatek,mtd-eeprom = <&factory 0x8000>;
|
||||
ieee80211-freq-limit = <5000000 6000000>;
|
||||
};
|
||||
};
|
||||
|
||||
&wmac {
|
||||
ralink,mtd-eeprom = <&factory 0x0>;
|
||||
};
|
||||
|
|
@ -100,6 +100,12 @@ define Build/mkdlinkfw-factory
|
|||
mv $@.new $@
|
||||
endef
|
||||
|
||||
define Build/netis-tail
|
||||
echo -n $(1) >> $@
|
||||
echo -n $(UIMAGE_NAME)-yun | $(STAGING_DIR_HOST)/bin/mkhash md5 | \
|
||||
sed 's/../\\\\x&/g' | xargs echo -ne >> $@
|
||||
endef
|
||||
|
||||
define Build/poray-header
|
||||
$(STAGING_DIR_HOST)/bin/mkporayfw $(1) -f $@ -o $@.new
|
||||
mv $@.new $@
|
||||
|
|
|
|||
|
|
@ -700,6 +700,17 @@ define Device/netgear_wn3000rp-v3
|
|||
endef
|
||||
TARGET_DEVICES += netgear_wn3000rp-v3
|
||||
|
||||
define Device/netis_wf2770
|
||||
SOC := mt7620a
|
||||
IMAGE_SIZE := 16064k
|
||||
UIMAGE_NAME := WF2770_0.0.00
|
||||
DEVICE_VENDOR := NETIS
|
||||
DEVICE_MODEL := WF2770
|
||||
DEVICE_PACKAGES := kmod-mt76x0e
|
||||
KERNEL_INITRAMFS := $(KERNEL_DTB) | netis-tail WF2770 | uImage lzma
|
||||
endef
|
||||
TARGET_DEVICES += netis_wf2770
|
||||
|
||||
define Device/nexx_wt3020-4m
|
||||
SOC := mt7620n
|
||||
BLOCKSIZE := 4k
|
||||
|
|
|
|||
|
|
@ -81,12 +81,6 @@ define Build/iodata-mstc-header
|
|||
)
|
||||
endef
|
||||
|
||||
define Build/netis-tail
|
||||
echo -n $(1) >> $@
|
||||
echo -n $(UIMAGE_NAME)-yun | $(STAGING_DIR_HOST)/bin/mkhash md5 | \
|
||||
sed 's/../\\\\x&/g' | xargs echo -ne >> $@
|
||||
endef
|
||||
|
||||
define Build/ubnt-erx-factory-image
|
||||
if [ -e $(KDIR)/tmp/$(KERNEL_INITRAMFS_IMAGE) -a "$$(stat -c%s $@)" -lt "$(KERNEL_SIZE)" ]; then \
|
||||
echo '21001:6' > $(1).compat; \
|
||||
|
|
|
|||
|
|
@ -170,6 +170,7 @@ ramips_setup_interfaces()
|
|||
"1:lan:4" "2:lan:3" "4:lan:2" "5:lan:1" "0:wan" "6@eth0"
|
||||
;;
|
||||
linksys,e1700|\
|
||||
netis,wf2770|\
|
||||
ralink,mt7620a-mt7530-evb)
|
||||
ucidef_add_switch "switch0"
|
||||
ucidef_add_switch_attr "switch0" "enable" "false"
|
||||
|
|
@ -338,6 +339,10 @@ ramips_setup_macs()
|
|||
linksys,e1700)
|
||||
wan_mac=$(mtd_get_mac_ascii config WAN_MAC_ADDR)
|
||||
;;
|
||||
netis,wf2770)
|
||||
wan_mac=$(mtd_get_mac_binary factory 0x2e)
|
||||
label_mac=$wan_mac
|
||||
;;
|
||||
tplink,archer-c2-v1|\
|
||||
tplink,archer-c20-v1|\
|
||||
tplink,archer-c20i|\
|
||||
|
|
|
|||
Loading…
Reference in New Issue