ar71xx: Set eth1 MAC address from EEPROM for WNDR3700

The WNDR3700's art/caldata partition contains three MAC addresses at
offsets 0, 6, and 12, used for eth0/wlan0 (shared), eth1, and wlan1,
respectively. The existing code configures eth1's MAC address by adding
1 to eth0's instead of using the value stored in the EEPROM. This patch
causes the stored value to be used directly. (On my WNDR3700s, the three
stored addresses are all sequential anyway.)

Signed-off-by: Mark Mentovai <mark@moxienet.com>

SVN-Revision: 23876
lede-17.01
Felix Fietkau 2010-11-04 18:46:07 +00:00
parent fc28e1cd7d
commit 91b6c63adc
1 changed files with 7 additions and 2 deletions

View File

@ -40,6 +40,9 @@
#define WNDR3700_BUTTONS_POLL_INTERVAL 20
#define WNDR3700_ETH0_MAC_OFFSET 0
#define WNDR3700_ETH1_MAC_OFFSET 0x6
#define WNDR3700_WMAC0_MAC_OFFSET 0
#define WNDR3700_WMAC1_MAC_OFFSET 0xc
#define WNDR3700_CALDATA0_OFFSET 0x1000
@ -168,14 +171,16 @@ static void __init wndr3700_setup(void)
{
u8 *art = (u8 *) KSEG1ADDR(0x1fff0000);
ar71xx_init_mac(ar71xx_eth0_data.mac_addr, art, 0);
ar71xx_init_mac(ar71xx_eth0_data.mac_addr,
art + WNDR3700_ETH0_MAC_OFFSET, 0);
ar71xx_eth0_pll_data.pll_1000 = 0x11110000;
ar71xx_eth0_data.mii_bus_dev = &wndr3700_rtl8366s_device.dev;
ar71xx_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII;
ar71xx_eth0_data.speed = SPEED_1000;
ar71xx_eth0_data.duplex = DUPLEX_FULL;
ar71xx_init_mac(ar71xx_eth1_data.mac_addr, art, 1);
ar71xx_init_mac(ar71xx_eth1_data.mac_addr,
art + WNDR3700_ETH1_MAC_OFFSET, 0);
ar71xx_eth1_pll_data.pll_1000 = 0x11110000;
ar71xx_eth1_data.mii_bus_dev = &wndr3700_rtl8366s_device.dev;
ar71xx_eth1_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII;