ar71xx: fix QCA955X SGMII link loss

The QCA955X is affected by a hardware bug which causes link-loss of the
SGMII link between SoC and PHY. This happens on change of link-state or
speed.

It is not really known what causes this bug. It definitely occurs when
using a AR8033 Gigabit Ethernet PHY.

Qualcomm solves this Bug in a similar fashion. We need to apply the fix
on a per-device base via platform-data as performing the fixup work will
break connectivity in case the SGMII interface is connected to a Switch.

This bug was first proposed to be fixed by Sven Eckelmann in 2016.
 https://patchwork.ozlabs.org/patch/604782/

Based-on-patch-by: Sven Eckelmann <sven.eckelmann@open-mesh.com>
Signed-off-by: David Bauer <mail@david-bauer.net>
(cherry picked from commit f4f99ec973)

target/linux/ar71xx/files/arch/mips/ath79/mach-fritz450e.c

@@ -155,6 +155,7 @@ static void __init fritz450E_setup(void) {
 	ath79_eth0_data.mii_bus_dev = &ath79_mdio1_device.dev;
 	ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_SGMII;
 	ath79_eth0_data.phy_mask = BIT(FRITZ450E_PHY_ADDRESS);
+	ath79_eth0_data.enable_sgmii_fixup = 1;
 	ath79_eth0_pll_data.pll_1000 = 0x03000000;
 	ath79_eth0_pll_data.pll_100 = 0x00000101;
 	ath79_eth0_pll_data.pll_10 = 0x00001313;

target/linux/ar71xx/files/arch/mips/include/asm/mach-ath79/ag71xx_platform.h

@@ -37,6 +37,7 @@ struct ag71xx_platform_data {
 	u8		is_ar724x:1;
 	u8		has_ar8216:1;
 	u8		use_flow_control:1;
+	u8		enable_sgmii_fixup:1;
 	u8		disable_inline_checksum_engine:1;
 
 	struct ag71xx_switch_platform_data *switch_data;

target/linux/ar71xx/files/drivers/net/ethernet/atheros/ag71xx/ag71xx.h

@@ -66,6 +66,8 @@
 #define AG71XX_TX_RING_SIZE_MAX		128
 #define AG71XX_RX_RING_SIZE_MAX		256
 
+#define QCA955X_SGMII_LINK_WAR_MAX_TRY	10
+
 #ifdef CONFIG_AG71XX_DEBUG
 #define DBG(fmt, args...)	pr_debug(fmt, ## args)
 #else

target/linux/ar71xx/files/drivers/net/ethernet/atheros/ag71xx/ag71xx_main.c

@@ -31,6 +31,7 @@ MODULE_PARM_DESC(msg_level, "Message level (-1=defaults,0=none,...,16=all)");
 #define ETH_SWITCH_HEADER_LEN	2
 
 static int ag71xx_tx_packets(struct ag71xx *ag, bool flush);
+static void ag71xx_qca955x_sgmii_init(void);
 
 static inline unsigned int ag71xx_max_frame_len(unsigned int mtu)
 {
@@ -610,6 +611,9 @@ __ag71xx_link_adjust(struct ag71xx *ag, bool update)
 	if (update && pdata->set_speed)
 		pdata->set_speed(ag->speed);
 
+	if (update && pdata->enable_sgmii_fixup)
+		ag71xx_qca955x_sgmii_init();
+
 	ag71xx_wr(ag, AG71XX_REG_MAC_CFG2, cfg2);
 	ag71xx_wr(ag, AG71XX_REG_FIFO_CFG5, fifo5);
 	ag71xx_wr(ag, AG71XX_REG_MAC_IFCTL, ifctl);
@@ -913,6 +917,81 @@ static void ag71xx_tx_timeout(struct net_device *dev)
 	schedule_delayed_work(&ag->restart_work, 1);
 }
 
+static void ag71xx_bit_set(void __iomem *reg, u32 bit)
+{
+	u32 val = __raw_readl(reg) | bit;
+	__raw_writel(val, reg);
+	__raw_readl(reg);
+}
+
+static void ag71xx_bit_clear(void __iomem *reg, u32 bit)
+{
+	u32 val = __raw_readl(reg) & ~bit;
+	__raw_writel(val, reg);
+	__raw_readl(reg);
+}
+
+static void ag71xx_qca955x_sgmii_init()
+{
+	void __iomem *gmac_base;
+	u32 mr_an_status, sgmii_status;
+	u8 tries = 0;
+
+	gmac_base = ioremap_nocache(QCA955X_GMAC_BASE, QCA955X_GMAC_SIZE);
+
+	if (!gmac_base)
+		goto sgmii_out;
+
+	mr_an_status = __raw_readl(gmac_base + QCA955X_GMAC_REG_MR_AN_STATUS);
+	if (!(mr_an_status & QCA955X_MR_AN_STATUS_AN_ABILITY))
+		goto sgmii_out;
+
+	__raw_writel(QCA955X_SGMII_RESET_RX_CLK_N_RESET ,
+		     gmac_base + QCA955X_GMAC_REG_SGMII_RESET);
+	__raw_readl(gmac_base + QCA955X_GMAC_REG_SGMII_RESET);
+	udelay(10);
+
+	/* Init sequence */
+	ag71xx_bit_set(gmac_base + QCA955X_GMAC_REG_SGMII_RESET,
+		       QCA955X_SGMII_RESET_HW_RX_125M_N);
+	udelay(10);
+
+	ag71xx_bit_set(gmac_base + QCA955X_GMAC_REG_SGMII_RESET,
+		       QCA955X_SGMII_RESET_RX_125M_N);
+	udelay(10);
+
+	ag71xx_bit_set(gmac_base + QCA955X_GMAC_REG_SGMII_RESET,
+		       QCA955X_SGMII_RESET_TX_125M_N);
+	udelay(10);
+
+	ag71xx_bit_set(gmac_base + QCA955X_GMAC_REG_SGMII_RESET,
+		       QCA955X_SGMII_RESET_RX_CLK_N);
+	udelay(10);
+
+	ag71xx_bit_set(gmac_base + QCA955X_GMAC_REG_SGMII_RESET,
+		       QCA955X_SGMII_RESET_TX_CLK_N);
+	udelay(10);
+
+	do {
+		ag71xx_bit_set(gmac_base + QCA955X_GMAC_REG_MR_AN_CONTROL,
+			       QCA955X_MR_AN_CONTROL_PHY_RESET |
+			       QCA955X_MR_AN_CONTROL_AN_ENABLE);
+		udelay(100);
+		ag71xx_bit_clear(gmac_base + QCA955X_GMAC_REG_MR_AN_CONTROL,
+				 QCA955X_MR_AN_CONTROL_PHY_RESET);
+		mdelay(10);
+		sgmii_status = __raw_readl(gmac_base + QCA955X_GMAC_REG_SGMII_DEBUG) & 0xF;
+
+		if (tries++ >= QCA955X_SGMII_LINK_WAR_MAX_TRY) {
+			pr_warn("ag71xx: max retries for SGMII fixup exceeded!\n");
+			break;
+		}
+	} while (!(sgmii_status == 0xf || sgmii_status == 0x10));
+
+sgmii_out:
+	iounmap(gmac_base);
+}
+
 static void ag71xx_restart_work_func(struct work_struct *work)
 {
 	struct ag71xx *ag = container_of(work, struct ag71xx, restart_work.work);

target/linux/ar71xx/patches-4.9/940-qca955x-add-more-registers.patch

@@ -0,0 +1,44 @@
+Index: linux-4.9.111/arch/mips/include/asm/mach-ath79/ar71xx_regs.h
+===================================================================
+--- linux-4.9.111.orig/arch/mips/include/asm/mach-ath79/ar71xx_regs.h
++++ linux-4.9.111/arch/mips/include/asm/mach-ath79/ar71xx_regs.h
+@@ -134,7 +134,7 @@
+ #define QCA955X_PCI_CTRL_SIZE	0x100
+ 
+ #define QCA955X_GMAC_BASE	(AR71XX_APB_BASE + 0x00070000)
+-#define QCA955X_GMAC_SIZE	0x40
++#define QCA955X_GMAC_SIZE	0x64
+ #define QCA955X_WMAC_BASE	(AR71XX_APB_BASE + 0x00100000)
+ #define QCA955X_WMAC_SIZE	0x20000
+ #define QCA955X_EHCI0_BASE	0x1b000000
+@@ -1269,7 +1269,11 @@
+  */
+ 
+ #define QCA955X_GMAC_REG_ETH_CFG	0x00
++#define QCA955X_GMAC_REG_SGMII_RESET	0x14
+ #define QCA955X_GMAC_REG_SGMII_SERDES	0x18
++#define QCA955X_GMAC_REG_MR_AN_CONTROL	0x1c
++#define QCA955X_GMAC_REG_MR_AN_STATUS	0x20
++#define QCA955X_GMAC_REG_SGMII_DEBUG	0x58
+ 
+ #define QCA955X_ETH_CFG_RGMII_EN	BIT(0)
+ #define QCA955X_ETH_CFG_MII_GE0		BIT(1)
+@@ -1291,6 +1295,18 @@
+ #define QCA955X_ETH_CFG_TXE_DELAY_MASK	0x3
+ #define QCA955X_ETH_CFG_TXE_DELAY_SHIFT	20
+ 
++#define QCA955X_SGMII_RESET_RX_CLK_N_RESET	0x0
++#define QCA955X_SGMII_RESET_RX_CLK_N		BIT(0)
++#define QCA955X_SGMII_RESET_TX_CLK_N		BIT(1)
++#define QCA955X_SGMII_RESET_RX_125M_N		BIT(2)
++#define QCA955X_SGMII_RESET_TX_125M_N		BIT(3)
++#define QCA955X_SGMII_RESET_HW_RX_125M_N	BIT(4)
++
++#define QCA955X_MR_AN_CONTROL_PHY_RESET	BIT(15)
++#define QCA955X_MR_AN_CONTROL_AN_ENABLE	BIT(12)
++
++#define QCA955X_MR_AN_STATUS_AN_ABILITY	BIT(3)
++
+ #define QCA955X_SGMII_SERDES_LOCK_DETECT_STATUS	BIT(15)
+ #define QCA955X_SGMII_SERDES_RES_CALIBRATION_SHIFT 23
+ #define QCA955X_SGMII_SERDES_RES_CALIBRATION_MASK 0xf