mirror of https://github.com/hak5/openwrt.git
32 lines
1005 B
Diff
32 lines
1005 B
Diff
|
--- linux-2.6.27/drivers/net/au1000_eth.c 2008-10-18 22:37:52.000000000 +0200
|
||
|
|
+++ linux-2.6.27.new/drivers/net/au1000_eth.c 2008-11-02 22:03:14.000000000 +0100
|
||
|
|
@@ -187,6 +187,15 @@
|
||
|
|
# undef AU1XXX_PHY1_IRQ
|
||
|
|
#endif
|
||
|
|
|
||
|
|
+#if defined(CONFIG_MIPS_MTX1)
|
||
|
|
+/*
|
||
|
|
+ * 4G MeshCube (MTX-1) board
|
||
|
|
+ * PHY is at address 31 on MAC0
|
||
|
|
+ * autodetect fails if not searched for highest address !
|
||
|
|
+ */
|
||
|
|
+# define AU1XXX_PHY_SEARCH_HIGHEST_ADDR
|
||
|
|
+#endif
|
||
|
|
+
|
||
|
|
#if defined(AU1XXX_PHY0_BUSID) && (AU1XXX_PHY0_BUSID > 0)
|
||
|
|
# error MAC0-associated PHY attached 2nd MACs MII bus not supported yet
|
||
|
|
#endif
|
||
|
|
@@ -383,6 +392,12 @@
|
||
|
|
aup->old_duplex = -1;
|
||
|
|
aup->phy_dev = phydev;
|
||
|
|
|
||
|
|
+#ifdef CONFIG_MIPS_MTX1
|
||
|
|
+ /* set up ethernet jack LEDs on the 4G MeshCube (MTX-1 board) */
|
||
|
|
+ printk(KERN_INFO "MTX-1 PHY: updating LED settings\n");
|
||
|
|
+ phy_write(phydev, 0x11, 0xff80);
|
||
|
|
+#endif
|
||
|
|
+
|
||
|
|
printk(KERN_INFO "%s: attached PHY driver [%s] "
|
||
|
|
"(mii_bus:phy_addr=%s, irq=%d)\n",
|
||
|
|
dev->name, phydev->drv->name, phydev->dev.bus_id, phydev->irq);
|