openwrt/target/linux/bcm53xx/patches-4.4/406-mtd-m25p80-use-single-SPI-message-for-writing-data.patch

From: =?UTF-8?q?Rafa=C5=82=20Mi=C5=82ecki?= <zajec5@gmail.com>
Subject: [PATCH] mtd: m25p80: use single SPI message for writing data
MIME-Version: 1.0
Content-Type: text/plain; charset=UTF-8
Content-Transfer-Encoding: 8bit

On all 3 tested Northstar devices with following flash memories:
mx25l6405d (8192 Kbytes)
mx25l12805d (16384 Kbytes)
mx25l25635e (32768 Kbytes)
I noticed writing to be broken. Not a single bit was changed leaving all
bytes set to 0xff.

This is most likely some problem related to the SPI controller or its
driver. Using a single SPI message seems to workaround this. Of course
it's not perfect solution as copying whole data into a new buffer makes
writing slower.

Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
---

--- a/drivers/mtd/devices/m25p80.c
+++ b/drivers/mtd/devices/m25p80.c
@@ -78,29 +78,30 @@ static void m25p80_write(struct spi_nor
 {
 	struct m25p *flash = nor->priv;
 	struct spi_device *spi = flash->spi;
+	u8 *command = kzalloc(MAX_CMD_SIZE + len, GFP_KERNEL);
 	struct spi_transfer t[2] = {};
 	struct spi_message m;
 	int cmd_sz = m25p_cmdsz(nor);
+	int i;
 
 	spi_message_init(&m);
 
 	if (nor->program_opcode == SPINOR_OP_AAI_WP && nor->sst_write_second)
 		cmd_sz = 1;
 
-	flash->command[0] = nor->program_opcode;
-	m25p_addr2cmd(nor, to, flash->command);
+	command[0] = nor->program_opcode;
+	m25p_addr2cmd(nor, to, command);
+	memcpy(&command[cmd_sz], buf, len);
 
-	t[0].tx_buf = flash->command;
-	t[0].len = cmd_sz;
+	t[0].tx_buf = command;
+	t[0].len = cmd_sz + len;
 	spi_message_add_tail(&t[0], &m);
 
-	t[1].tx_buf = buf;
-	t[1].len = len;
-	spi_message_add_tail(&t[1], &m);
-
 	spi_sync(spi, &m);
 
 	*retlen += m.actual_length - cmd_sz;
+
+	kfree(command);
 }
 
 static inline unsigned int m25p80_rx_nbits(struct spi_nor *nor)