openwrt-owl/target/linux/ramips
Maxim Anisimov 8956eb502d ramips: add support for TP-Link TL-WR842N v5
TP-Link TL-WR842N v5 are simple N300 router with 5-port FE switch and
non-detachable antennas. Its very similar to TP-Link TL-MR3420 V5.

Specification:

- MT7628N/N (580 MHz)
- 64 MB of RAM (DDR2)
- 8 MB of FLASH
- 2T2R 2.4 GHz
- 5x 10/100 Mbps Ethernet
- 2x external, non-detachable antennas
- USB 2.0 Port
- UART (J1) header on PCB (115200 8n1)
- 7x LED, 2x button, power input switch

Flash instruction:

The only way to flash OpenWrt image in wr842nv5 is to use
tftp recovery mode in U-Boot:

1. Configure PC with static IP 192.168.0.225/24 and tftp server.
2. Rename "lede-ramips-mt7628-tplink_tl-wr842n-v5-squashfs-tftp-recovery.bin"
   to "tp_recovery.bin" and place it in tftp server directory.
3. Connect PC with one of LAN ports, press the reset button, power up
   the router and keep button pressed for around 6-7 seconds, until
   device starts downloading the file.
4. Router will download file from server, write it to flash and reboot.

Signed-off-by: Maxim Anisimov <maxim.anisimov.ua@gmail.com>
2018-06-16 10:08:51 +02:00
..
base-files ramips: add support for TP-Link TL-WR842N v5 2018-06-16 10:08:51 +02:00
dts ramips: add support for TP-Link TL-WR842N v5 2018-06-16 10:08:51 +02:00
files-4.14/drivers ramips: mt7621: fix mtu setting with kernel 4.14 2018-06-16 10:08:51 +02:00
image ramips: add support for TP-Link TL-WR842N v5 2018-06-16 10:08:51 +02:00
mt76x8 kernel: enable THIN_ARCHIVES by default 2018-05-22 07:55:20 +02:00
mt7620 kernel: enable THIN_ARCHIVES by default 2018-05-22 07:55:20 +02:00
mt7621 ramips: mir3g dts define usb port Vcc volt regulator GPIO 2018-06-08 09:31:36 +02:00
patches-4.14 ramips: rename ethernet driver folder to the same one that upstream uses 2018-06-13 12:54:25 +02:00
rt288x kernel: enable THIN_ARCHIVES by default 2018-05-22 07:55:20 +02:00
rt305x ramips: add dwr-512 jboot firmware configuration 2018-04-08 09:51:06 +02:00
rt3883 kernel: enable THIN_ARCHIVES by default 2018-05-22 07:55:20 +02:00
Makefile ramips: switch to linux 4.14 2018-04-06 18:07:43 +02:00
modules.mk ramips: rename pwm kernel module 2018-04-08 12:35:33 +02:00