openwrt-owl

History

Gabor Juhos 39994008cb linux: move certain disabled symbols to the generic configs * CONFIG_ARCH_DMA_ADDR_T_64BIT * CONFIG_ARCH_HAS_ILOG2_U32 * CONFIG_ARCH_HAS_ILOG2_U64 * CONFIG_ARCH_PHYS_ADDR_T_64BIT * CONFIG_ARCH_SUPPORTS_MSI * CONFIG_GENERIC_CPU_DEVICES * CONFIG_HWMON_DEBUG_CHIP * CONFIG_I2C_PXA_PCI * CONFIG_LEDS_GPIO * CONFIG_MINIX_FS_NATIVE_ENDIAN * CONFIG_MLX4_CORE * CONFIG_POWER_SUPPLY * CONFIG_POWER_SUPPLY_DEBUG * CONFIG_QUOTACTL * CONFIG_SDIO_UART * CONFIG_SENSORS_K10TEMP * CONFIG_SENSORS_SCH56XX_COMMON * CONFIG_SENSORS_VIA_CPUTEMP * CONFIG_SERIO_AMBAKMI * CONFIG_SERIO_I8042 * CONFIG_SERIO_LIBPS2 * CONFIG_SERIO_PCIPS2 * CONFIG_SERIO_RAW * CONFIG_SERIO_SERPORT * CONFIG_SPI_BITBANG * CONFIG_SPI_GPIO SVN-Revision: 31737		2012-05-15 10:58:52 +00:00
..
base-files/etc	base-files: use shutdown instead of stop when the system goes down (patch by tripolar)	2010-12-13 08:01:21 +00:00
image	add qemu target	2010-11-08 07:31:36 +00:00
patches-3.3	realview: add 3.3 support	2012-05-14 15:48:29 +00:00
Makefile	realview: switch to 3.3	2012-05-14 15:48:31 +00:00
README	add README	2010-11-08 09:41:32 +00:00
config-3.3	linux: move certain disabled symbols to the generic configs	2012-05-15 10:58:52 +00:00

README

This ARM Ltd. Realview target is intended to be used with the Qemu emulator.
It can be used to prototype an OpenWrt firmware targetting ARM-based hardware.
One could also use it to troubleshoot ARM applications without access to real
hardware.

To use the images built by OpenWrt with qemu, use the following commands:

qemu-system-arm -M realview-eb-mpcore \
-kernel bin/realview/openwrt-realview-vmlinux.elf \
-nographic -m 128

and enjoy the system booting.