Eddi De Pieri 07bc0d6089 lantiq: fix pci issue if mem kernel parameter is used ... As specified by e0229a16b0 if the VR9 based router provides FXS ports and they should enabled then the following must added to the kernel command line: mem=[TOTALMEMSIZE-2M] vpe1_load_addr=ADDRESS vpe1_mem=2M By adding mem= parameter a pci device stop working correctly. The pci-lantiq.c module use get_num_physpages() to compute dynamically the memory amount of the board. The mem= make the module to compute in the wrong way the BAR11MASK, so in this situation the mask is misaligned with the dma area that the hardware expects. This patch is a port of what legacy ifxmips_pci.c does. Signed-off-by: Eddi De Pieri <eddi@depieri.net>		2016-11-12 21:04:15 +01:00
..
base-files	lantiq: use the device tree bindings from rt2x00 driver	2016-11-09 20:02:18 +01:00
dts	lantiq: use the device tree bindings from rt2x00 driver	2016-11-09 20:02:18 +01:00
files/firmware/lantiq	move GPHY FW blobs to non versioned folder	2013-03-14 18:42:21 +00:00
image	lantiq: use new build code for DGN3500	2016-10-19 19:06:15 +02:00
patches-4.4	lantiq: fix pci issue if mem kernel parameter is used	2016-11-12 21:04:15 +01:00
xrx200	lantiq: add vpe/watchdog modules to kernel	2016-10-31 16:51:33 +01:00
xway	lantiq: switch from 34k to 24k	2016-08-23 11:55:32 +02:00
xway_legacy	lantiq: switch from 34k to 24k	2016-08-23 11:55:32 +02:00
Makefile	use immediate set in target Makefiles	2016-09-10 15:30:38 +02:00
config-4.4	lantiq: add cpu temperatur sensor driver for xrx200	2016-08-03 15:30:13 +02:00
modules.mk	fix i2c-lantiq module	2012-12-16 10:03:18 +00:00