c2668207de
lantiq: add support for xrx200 firmware depending on soc type
...
Signed-off-by: Álvaro Fernández Rojas <noltari@gmail.com>
SVN-Revision: 42182
2014-08-18 13:09:08 +00:00
db2e450ab5
lantiq: export soc type
...
Signed-off-by: Álvaro Fernández Rojas <noltari@gmail.com>
SVN-Revision: 42181
2014-08-18 13:08:59 +00:00
c21a20cd78
lantiq: fix dgn3500 and td8970 wifi
...
ath9k failed to come up due to a bad mac addr
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 41860
2014-07-28 15:26:41 +00:00
6c46a10246
lantiq: refresh patches
...
this adds ben's ath9k fixup
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 41269
2014-06-19 14:12:59 +00:00
7a03f41940
lantiq: fix eep handling patch
...
0b79a4a66d17d2c7c12cde8d13637c1b0e5152c2 broke the patch
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 41005
2014-06-05 08:19:52 +00:00
f09ac641d6
lantiq: ath5k fix in wifi and ethernet eeprom handling patch.
...
ath5k fix in wifi and ethernet eeprom handling patch.
Without the line that adds the patch of_ath5k_eeprom_probe cause a
kernel panic, at least with the ARV4518PW.
Tested only in the modem-router mentioned above.
This patch is based in Bruno's hack present in patch #5454 .
Signed off by: Bruno Rodríguez <bruno.rodriguez.1980@gmail.com>
Signed off by: José Vázquez Fernández <ppvazquezfer@gmail.com>
SVN-Revision: 40999
2014-06-04 07:20:22 +00:00
fa48c0db1d
lantiq: fix up eth_mac and ath_eep support
...
this patch got messed up by the last rebase
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 40948
2014-06-02 12:45:29 +00:00
5ab4fe9c0e
lantiq: strip FCS from received ethernet frames on XRX200
...
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
SVN-Revision: 40719
2014-05-07 18:36:58 +00:00
5836cde0e0
Fix vr9_phy22f_a2x.bin firmware linking
...
vr9_phy22f_a2x.bin needs to be linked in order to get ethernet support.
Signed-off-by: Álvaro Fernández Rojas <noltari@gmail.com>
SVN-Revision: 40543
2014-04-22 08:08:06 +00:00
cdc53e2ec9
lantiq: fix maximum ethernet header length
...
The total ethernet frame length should be written to the hardware
register LTQ_ETOP_IGPLEN instead of just the value of the MTU. This
patch fixes network issues on various Danube boards, especially when
VLAN tagging is enabled.
Signed-off-by: Matti Laakso <malaakso at elisanet.fi>
SVN-Revision: 40541
2014-04-22 08:07:53 +00:00
d2812cb036
kernel: update 3.10 to 3.10.36
...
Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
SVN-Revision: 40467
2014-04-12 11:59:07 +00:00
a05356f48a
lantiq: nand fixes
...
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 40372
2014-04-03 14:27:02 +00:00
469b8297fa
lantiq: BT Home Hub 2B support - jedec probe
...
Lantiq nor patch. Adds support for jedec probing if cfi
probing fails.
Signed-off-by: Ben Mulvihill <ben.mulvihill@gmail.com>
SVN-Revision: 40369
2014-04-03 14:26:50 +00:00
78a7ae428f
lantiq: make td8970 wifi led work
...
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 40368
2014-04-03 14:26:46 +00:00
8b0507c9ca
lantiq: fix mtd_split for brnboot firmware images
...
The existing code only tries to split a parition with name "rootfs"
while actually looking for kernel+rootfs, where usually "firmware" is
used as a partition name. This doesn't make sense, as even if there
was a partition 'rootfs' given by mtdparts or via device-tree, this
code would lead to another partition called 'rootfs' being created
which would not be properly distinguished in the current user-space
code.
While potentially we could use CONFIG_MTD_SPLIT_FIRMWARE_NAME to make
that configurable, the lack of users of brnboot and the fact that we
can freely decide the partition name made me simply change the
hard-coded string constant from "rootfs" to "firmware".
(I'm going to add support for ARV7506PW which run brnboot and needs
this change)
SVN-Revision: 40324
2014-03-30 09:16:35 +00:00
0c73e85cd0
lantiq: fixup ath5k support
...
http://patchwork.openwrt.org/patch/4417/
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 40323
2014-03-30 09:16:31 +00:00
3a43738e21
lantiq: reset gphys on reboot
...
If gphys are not reset upstream uboot can not use them anymore.
Signed-off-by: Antonios Vamporakis <ant@area128.com>
SVN-Revision: 40318
2014-03-30 09:16:10 +00:00
82da5ca248
lantiq: add inital support for xrx200 switch
...
Signed-off-by: Antonios Vamporakis <ant@area128.com>
SVN-Revision: 40313
2014-03-30 09:15:50 +00:00
32e2246270
lantiq: xrx200: fix duplex
...
Both the GPL driver from ZyXEL and the xrx200 driver have this error. The flags
are reversed. Full duplex is marked as half and the other way around. With this
fix the switch will push full GBit speeds.
Signed-off-by: Antonios Vamporakis <ant@area128.com>
SVN-Revision: 40312
2014-03-30 09:15:46 +00:00
561a7ef93b
lantiq: fix nand/ebu locking
...
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 40310
2014-03-30 09:15:37 +00:00
d6a138141c
lantiq: add tffs driver
...
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 40309
2014-03-30 09:15:33 +00:00
f677b1bc7e
kernel: update 3.10 to 3.10.32
...
Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
SVN-Revision: 39707
2014-02-23 10:59:40 +00:00
6e0fd6d518
lantiq: fix typo in pinctl driver
...
Signed-off-by: Antonios Vamporakis <ant@area128.com>
SVN-Revision: 39588
2014-02-15 22:54:34 +00:00
a2543d72d8
kernel: update 3.10 to 3.10.28
...
Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
SVN-Revision: 39399
2014-01-26 11:30:34 +00:00
0e2586a774
kernel: update 3.10 to 3.10.26
...
Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
SVN-Revision: 39220
2014-01-11 16:06:37 +00:00
f1ef0b92be
kernel: update 3.10 to 3.10.21
...
Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
SVN-Revision: 38972
2013-12-01 09:59:53 +00:00
776c6c50ce
lantiq: move patch to proper folder
...
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 38884
2013-11-20 17:53:36 +00:00
06ada4b10f
lantiq: fix an endless loop in the vmmc platform code
...
this was caused by not honoured error return codes of of_gpio_count()
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 38878
2013-11-20 16:56:32 +00:00
35656042f1
kernel: update 3.10 to 3.10.18
...
Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
SVN-Revision: 38652
2013-11-05 08:25:45 +00:00
b6b06000eb
kernel: update 3.10 to 3.10.17
...
Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
SVN-Revision: 38506
2013-10-23 12:51:05 +00:00
1398a5d849
lantiq: fix eva partition split for squashfs
...
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 38325
2013-10-07 15:02:48 +00:00
9c8a5ef115
kernel: update 3.10 to 3.10.13
...
Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
SVN-Revision: 38228
2013-09-27 07:19:21 +00:00
0380904acb
kernel/3.10: refresh all target patches
...
Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
SVN-Revision: 38182
2013-09-25 17:13:24 +00:00
482b5f34e5
lantiq/3.10: unbreak the mtd-split patch
...
Compile tested only.
Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
SVN-Revision: 38180
2013-09-25 16:22:04 +00:00
f9f73ef2ec
lantiq: fix ath9k eeprom loading order bug
...
https://dev.openwrt.org/ticket/14131
http://patchwork.openwrt.org/patch/4038/
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 38041
2013-09-18 16:31:41 +00:00
1878a3d6ab
lantiq: add v3.10 patches
...
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 38031
2013-09-17 21:46:10 +00:00
John Crispin
Felix Fietkau
Gabor Juhos
Luka Perkov