dc4cfd3a64
Add 3.3 config files
...
SVN-Revision: 31672
2012-05-09 12:52:24 +00:00
75827c538d
Add missing 3.3 patches
...
SVN-Revision: 31671
2012-05-09 12:52:21 +00:00
7d638fbb2f
Drop 2.6.32 support
...
SVN-Revision: 31670
2012-05-09 12:52:19 +00:00
34018a630f
kernel: update linux 3.3 to 3.3.5
...
SVN-Revision: 31645
2012-05-07 20:11:43 +00:00
0ff3c396d3
kernel: rewrite the phy packet hook, put it in the network stack to avoid having to keep non-upstream ethernet driver changes
...
SVN-Revision: 31637
2012-05-06 21:19:14 +00:00
cbfce53831
kernel: update linux 3.3 to 3.3.4
...
SVN-Revision: 31541
2012-04-30 08:38:11 +00:00
22b4e6b882
kernel: update linux 3.2 to 3.2.16
...
SVN-Revision: 31459
2012-04-24 09:25:35 +00:00
d4f3677cba
Adding wifi eeprom extract for ARV752DPW - Easybox 802
...
Signed-off-by: Christian Rustmeier <rustmeier a.t. gmail dotty com>
SVN-Revision: 31443
2012-04-23 09:40:37 +00:00
87cdc0dd5b
change /etc/config/network according to actual VLAN config to enable LAN port 4 on the ARV4520PW board
...
The VLAN mapping on the ARV4520PW board is the following:
port on Router: | VLAN in software:
LAN 1 | 3
LAN 2 | 2
LAN 3 | 1
LAN 4 | 0
DSL | 4
So LAN4 is not VLAN4 but VLAN0 (VLAN4 is DSL port) -> set "3 2 1 0 5t" as default switch config.
SVN-Revision: 31391
2012-04-21 08:07:21 +00:00
a8f2bc682e
kernel: also update the targets to use 3.2.15
...
Thanks Gabor for spotting it.
SVN-Revision: 31337
2012-04-17 13:12:14 +00:00
3a9b6dc313
kernel: update linux 3.3 to 3.3.2
...
SVN-Revision: 31336
2012-04-17 12:51:02 +00:00
ee4c47a134
kernel: update linux 3.2 to 3.2.15
...
SVN-Revision: 31335
2012-04-17 12:50:54 +00:00
83948d6385
adds 3.3 patches and files
...
SVN-Revision: 31307
2012-04-16 12:31:48 +00:00
e3889bcf7c
update 3.2 patches
...
sync with lantiq kernel series
SVN-Revision: 31260
2012-04-12 12:33:56 +00:00
16b4cbcdd6
kernel: update linux 3.2 to 3.2.14
...
SVN-Revision: 31222
2012-04-09 14:48:51 +00:00
da3f3f8f9d
add Easybox 802 - ARV752DPW
...
Implements the ARV752DPW architecture in mach-arv.c
Signed-off-by: Christian Rustmeier <rustmeier@gmail.com>
SVN-Revision: 31206
2012-04-05 20:03:21 +00:00
94af65db49
enable usb on dgn3500
...
A power-enable toggle gpio is not available, it is always on and protected with a resettable fuse.
Signed-off-by: Pieter Voorthuijsen<p.voorthuijsen at gmail.com>
SVN-Revision: 31205
2012-04-05 20:03:19 +00:00
d87efd8c3c
kernel: update linux 3.2 to 3.2.13 and refresh patches
...
Also remove a duplicate patch from lantiq (already in generic).
SVN-Revision: 31158
2012-04-01 07:56:55 +00:00
5f799a0e97
ath9k: make endian check optional
...
Turns out it triggers on some AR71xx devices where no swapping should be done.
Enable endian check for the lantiq target.
SVN-Revision: 31084
2012-03-27 13:21:53 +00:00
b982e8166b
cleanup atheros wifi handling
...
Signed-off-by: Andrej Vlašić <andrej.vlasic0@gmail.com>
Signed-off-by: Luka Perkov <openwrt@lukaperkov.net>
SVN-Revision: 31064
2012-03-25 08:50:38 +00:00
5ea100c39b
cleanup image makefile
...
SVN-Revision: 31063
2012-03-25 08:50:32 +00:00
f27c030141
update /etc/uci-defaults/*
...
SVN-Revision: 31062
2012-03-25 08:50:30 +00:00
ba4a7fca7b
update profiles
...
SVN-Revision: 31061
2012-03-25 08:50:27 +00:00
0f6a9d5c7c
bump kernel to 3.2.12
...
SVN-Revision: 31060
2012-03-25 08:50:09 +00:00
db6e326c56
targets: replace madwifi in profiles with ath5k, madwifi is unmaintained
...
SVN-Revision: 31015
2012-03-19 09:58:13 +00:00
fab5be9b4f
lantiq: load dwc_otg early
...
Needed for using external rootfs on usb sticks.
Signed-off-by: Jonas Gorski <jonas.gorski@gmail.com>
SVN-Revision: 30940
2012-03-14 10:59:52 +00:00
e5798d7c9b
fixes etop locking issue
...
SVN-Revision: 30689
2012-02-23 07:42:00 +00:00
1a71f07d00
generate uboot environment data in target
...
With this patch it is possible to generate uboot environment config file
inside lantiq target. Currently it is only supporting GIGASX76X board.
uboot environment config is used by fw_printenv fw_setenv tools.
Signed-off-by: Luka Perkov <openwrt@lukaperkov.net>
SVN-Revision: 30537
2012-02-14 19:07:11 +00:00
7416a5f0aa
fix compile error in previous commit
...
SVN-Revision: 30534
2012-02-14 19:07:05 +00:00
cd1a204365
Support booting the Speedport W502V using BRN-BOOT.
...
While the disadvantage is less available flash space, it's easy and
safe to flash without opening the device.
Going back to the original firmware is also possible.
This patch add two firmware utilities, mkbrncmdline and mkbrnboot.
mkbrncmdline patches the uncompressed kernel so the registeres a0 to
a3 are initialized and the memory size is passed in.
mkbrnboot takes the lzma compressed kernel and squashfs images and
creates a firmware image that can be flashed using the BRN-BOOT
recovery kernel, which is booted by holding both buttons when
powering up the device and will listen on http://192.168.2.1 .
The firmware file from bin/lantiq/ to use is
openwrt-lantiq-danube-ARV4525PW-BRNDTW502-brnImage
The BRN-BOOT recovery kernel does size-check the image, so if it's
too big to fit into flash it will complain accordingly.
A second patch is needed to make the wired network interface work
since there is no u-boot to pre-initialise it.
Signed-off-by: Tobias Diedrich <ranma+openwrt@tdiedrich.de>
SVN-Revision: 30532
2012-02-14 17:48:04 +00:00
0b07769898
fixes irq locking in ethernet driver
...
SVN-Revision: 30522
2012-02-14 15:05:58 +00:00
55bf39e98c
fixes gpio_export patch
...
SVN-Revision: 30521
2012-02-14 15:05:57 +00:00
976d3eb854
add annex selection support to ltq_dsl package
...
SVN-Revision: 30518
2012-02-14 15:05:49 +00:00
1015fab0d7
kernel: update linux 3.1 to 3.1.10
...
SVN-Revision: 29966
2012-01-31 09:43:57 +00:00
49eb3fd845
gigaset 76x
...
* fixes leds
* adds all leds found on the sx763 board
* removes board_config from flash layout because wireless data is stored in kernel (ath5k)
* fix button handling
Signed-off-by: Luka Perkov <openwrt@lukaperkov.net>
SVN-Revision: 29763
2012-01-17 12:10:35 +00:00
c560444a58
kernel: update linux 3.1 to 3.1.9
...
SVN-Revision: 29726
2012-01-13 14:38:28 +00:00
e33bb9ec66
linux: update 3.1 to 3.1.4
...
SVN-Revision: 29470
2011-12-06 19:50:30 +00:00
bf7316424c
lantiq: bump to 3.1.3
...
SVN-Revision: 29348
2011-11-28 10:22:58 +00:00
9389593db9
lantiq: drop 009-MIPS-make-oprofile-use-cp0_perfcount_irq-if-it-is-se.patch
...
This patch is/was a duplicate of generic/patches-3.1/307-mips_oprofile_fix.patch
SVN-Revision: 29294
2011-11-23 12:22:15 +00:00
4982ca983c
lantiq: * fixes ath5k eeprom handling * fixes sx76x * adds sx76x to userland api * minor style cleanups
...
Signed-of-by: Andrej Vlašić <andrej.vlasic0@gmail.com>
SVN-Revision: 29292
2011-11-22 18:50:51 +00:00
bbe96f13a6
lantiq: add runtime generation of /etc/config/network
...
SVN-Revision: 29161
2011-11-15 18:21:00 +00:00
79a4642b40
lantiq: fix falcon build breakage
...
dev-wifi-rt2x00 fails to build on falcon due to missing pci
SVN-Revision: 29129
2011-11-14 18:55:58 +00:00
d8acb75009
linux: update 3.1 to 3.1.1
...
SVN-Revision: 29007
2011-11-13 10:48:05 +00:00
a8797d0de6
lantiq: add uci-defaults code for handling leds
...
SVN-Revision: 29004
2011-11-12 23:40:21 +00:00
832e02cd77
lantiq: add /lib/lantiq.sh and make hotplug handlers use it
...
SVN-Revision: 29003
2011-11-12 23:40:16 +00:00
5dcbbf0160
lantiq: rename leds
...
SVN-Revision: 29002
2011-11-12 23:40:12 +00:00
d84b7596d9
lantiq: split compat headers out of bsp header patch
...
SVN-Revision: 29001
2011-11-12 23:40:07 +00:00
2cff80f015
lantiq: adds hotplug handler for loading rt2x00 firmware
...
SVN-Revision: 29000
2011-11-12 23:40:01 +00:00
3660c51c40
lantiq: adds hotplug handler for handling buttons and makes w303v work with it
...
SVN-Revision: 28999
2011-11-12 23:39:56 +00:00
4248705108
lantiq: cleanup default package selection
...
SVN-Revision: 28998
2011-11-12 23:39:51 +00:00
John Crispin
Gabor Juhos
Felix Fietkau
Jonas Gorski
Mirko Vogt