8957f39064
ramips: ramips_esw: use a private structure for the functions
...
SVN-Revision: 24329
2010-12-08 10:14:54 +00:00
f586bb26dd
ethernet driver fixup for ppc4xx
...
SVN-Revision: 24328
2010-12-08 08:59:31 +00:00
7224337d71
Profiles: GW6X00: Replace ext2 module with ext4 as ext2 and 3 are going away. Remove kmod-loop as the need for it has been superseded by block-extroot, and remove kmod-fs-vfat as it takes space and is rarely needed.
...
SVN-Revision: 24316
2010-12-08 00:40:31 +00:00
2a86dcc3d6
Profiles: Make buttons and led modules included by default so that failsafe will work in the case of builds for releases.
...
SVN-Revision: 24315
2010-12-08 00:40:28 +00:00
c6ef9a0720
Profiles: Move wpad-mini to the profiles that use it, rather than default for all profiles (because -wpad-mini means it's not selectable, which isn't what we always want for the No WiFi profile
...
SVN-Revision: 24314
2010-12-08 00:40:24 +00:00
4ab2416621
flash_chips: Added Macronix MX29LV640T Flash Chip support previously mistakenly added to brcm63xx. Thanks blunoise.
...
SVN-Revision: 24313
2010-12-07 19:45:08 +00:00
f8ed133c0a
patches: Renamed 150-led_count to 141-led_count so it comes before the 15-alice_gate2_leds.patch as which led count was mistakenly given the same number.
...
SVN-Revision: 24310
2010-12-07 17:32:29 +00:00
0e839ea40d
Revert "[brcm63xx] patches-2.6.35: Added flash chip definition for Macronix MX29LV640T."
...
This reverts commit 43511418ae2771a6662a83a254f06e37f4ac19e5.
It belongs in generic not brcm63xx.
SVN-Revision: 24308
2010-12-07 17:02:31 +00:00
183d628485
patches-2.6.35: Added flash chip definition for Macronix MX29LV640T. Thanks blunoise
...
SVN-Revision: 24307
2010-12-07 16:42:23 +00:00
8f9b14dafe
boards: Added GW6x00 fixups and GPIOs. The GW6200 GPIOs are different than the reference design 96348GW so we use fixup to allow us to define the correct ones, also the GW6000 has no GPIO-controlled leds.
...
SVN-Revision: 24305
2010-12-07 15:15:54 +00:00
3baa168e09
patches: Refreshed patches after led_count
...
SVN-Revision: 24304
2010-12-07 15:15:51 +00:00
b963cbde33
board definitions: Added patch for calculating led count, which was part of the patch removed in the previous commit
...
SVN-Revision: 24303
2010-12-07 15:15:47 +00:00
e5ca4d81f4
Remove patch 140-new_bcm96348gw_leds because it is really the GW6200 leds, not the generic 96348GW. Another commit will add the GW6200 specific boardid and leds. This removal reverts the 96348GW leds to the reference design GPIOs.
...
SVN-Revision: 24302
2010-12-07 15:15:41 +00:00
0fc35b30e3
kernel: fix cryptodev with kernel >= 2.6.35
...
The fix is from http://sourceforge.net/mailarchive/forum.php?thread_name=20100906035717.GA7562%40mcafee.com&forum_name=ocf-linux-users
Thank you tripolar for reporting the issue and finding a solution for it.
SVN-Revision: 24286
2010-12-06 17:01:10 +00:00
ad24e14b35
base-files: Added the preinit information for reset button and preinit indication led, and preinit interface
...
SVN-Revision: 24276
2010-12-06 06:46:03 +00:00
244db5ac6a
board definition: Fixed CPVA642 LED definitions
...
SVN-Revision: 24275
2010-12-06 06:45:57 +00:00
8316194016
board definitions: Added CPVA642 GPIO leds and buttons and refreshed patches later in series due to fuzz
...
SVN-Revision: 24274
2010-12-06 04:31:23 +00:00
7129521696
base-files: Added network defconfig because board only has one ethernet (4-port switch)
...
SVN-Revision: 24273
2010-12-06 02:01:08 +00:00
0449d92dd7
ramips: add support for 2.6.36
...
SVN-Revision: 24270
2010-12-05 20:14:38 +00:00
01a5cb48c8
ramips: default profile fix
...
Fix package names in default profiles.
Signed-off-by: Roman Yeryomin <roman@advem.lv>
SVN-Revision: 24269
2010-12-05 20:14:35 +00:00
47dd3b9fea
ramips: use tabs instead of spaces in mach-f5d8235-v2.c
...
SVN-Revision: 24268
2010-12-05 20:14:30 +00:00
2f7964de3e
brcm47xx: do not read from CFE
...
SVN-Revision: 24267
2010-12-05 19:20:26 +00:00
852f7b37ed
brcm47xx: backport patch from kernel 2.6.37
...
Backport patches from r24162
brcm47xx: reorder patches like they were commitet upstream
SVN-Revision: 24266
2010-12-05 19:19:50 +00:00
7b1ae48645
brcm47xx: use on common files dir
...
SVN-Revision: 24264
2010-12-05 18:34:58 +00:00
044ea01f9c
preliminary support for Freescale MPC85xx based boards
...
SVN-Revision: 24259
2010-12-05 11:38:59 +00:00
8067f3f3cc
ar71xx: work around a PCI controller bug which causes reads to the PCI_COMMAND register to return bogus values - properly fixes ath9k module reload issues
...
SVN-Revision: 24236
2010-12-04 01:32:15 +00:00
187359dc67
remove unused kernel versions, make 2.6.36 the default
...
SVN-Revision: 24223
2010-12-03 09:19:52 +00:00
41b3383499
brcm47xx: Add edimax PS1208mfg support
...
Thank you clemvangelis for the patches. (closes #7672 )
SVN-Revision: 24217
2010-12-02 21:27:54 +00:00
6f7e2d4ce8
tune rtl8366s default config, make vlan 1 cpu port tagged and use eth0.1 for the lan interface - this brings the configuration more in line with other switch setups
...
SVN-Revision: 24215
2010-12-02 20:19:55 +00:00
79c24b2cb0
ar71xx: refresh patches
...
SVN-Revision: 24210
2010-12-01 18:40:01 +00:00
17564e7db8
generic: yet another missing config symbol for 2.6.37
...
SVN-Revision: 24208
2010-12-01 18:39:55 +00:00
30b950154b
add a new image for the TEW-652BRP which can be used with the bootloader recovery option
...
SVN-Revision: 24196
2010-11-30 02:04:57 +00:00
2fe5c1d124
backport two changes from kernel.org: 65e9b62d4503849b10bedfc29bff0473760cc597 ipv6: add special mode accept_ra=2 to accept RA while configured as router
...
c3bccac2fa76f1619dfe4fb7b9bee69de7f066d8
ipv6: add special mode forwarding=2 to send RS while configured as router
SVN-Revision: 24195
2010-11-30 01:52:51 +00:00
9677b65cb6
image Makefile: Corrected router imagename length limiting. Thanks KanjiMonster for reminding me.
...
SVN-Revision: 24191
2010-11-28 22:13:00 +00:00
314bce63e6
bcm63xx: Add support for the T-Com Speedport W 500V.
...
Add support for the T-Com Speedport W 500V using a special tagged image as it
identifies itself as a 96348GW, but has some gpios wired differently, and also
has only one ethernet port without a switch attached to it.
Signed-off-by: Jonas Gorski <jonas.gorski+openwrt@gmail.com>
SVN-Revision: 24190
2010-11-28 22:04:44 +00:00
3a49f669f2
bcm63xx: Add board id override fixup.
...
Add a fixup for the kernel to check the bcm tag of the image for a boardid in
the information1 field, and use that instead of the supplied one by cfe. This
is triggered by a + at the start of the information1 field.
Also modify the image generation to generate apropriately tagged images.
Signed-off-by: Jonas Gorski <jonas.gorski+openwrt@gmail.com>
SVN-Revision: 24189
2010-11-28 22:04:40 +00:00
c51d772e62
bcm63xx: Finalize support for DSL-274xB, rev C2.
...
The DSL-2740B/DSL-2741B rev C2 support was missing the board definition,
resulting in a kernel panic on boot.
This patch adds it, and also renames the generated image name to properly
reflect that it is for the revision C2, and for both the DSL-2740B and
DSL-2741B.
Signed-off-by: Jonas Gorski <jonas.gorski+openwrt@gmail.com>
SVN-Revision: 24188
2010-11-28 22:04:36 +00:00
8fa9b24a4c
bcm63xx: Allow 'colored' power leds.
...
Since some devices have more than one power led, they might be separated by
their color in the name. To also allow them to be on after leaving preinit,
set any status led starting with 'power' to on instead of only those with
the exact name of 'power'.
Signed-off-by: Jonas Gorski <jonas.gorski+openwrt@gmail.com>
SVN-Revision: 24187
2010-11-28 22:04:30 +00:00
fec30c8c80
bcm63xx: Don't hardcode the switch ethernet interface in preinit.
...
Currently eth1 is hardcoded as the expected interface switches in diagmode.
This patch replaces the eth1 with the ifname, and also directly tests if
the interface specified by ifname has a switch attached.
Signed-off-by: Jonas Gorski <jonas.gorski+openwrt@gmail.com>
SVN-Revision: 24186
2010-11-28 22:04:26 +00:00
b1b318750a
bcm63xx: Add defconfigs.
...
Port the mechanism for different default configurations from ar71xx and
use the old configuration as the default configuration. This should have
no functional differences to before.
While we are at it, remove the obsolete nat option.
Signed-off-by: Jonas Gorski <jonas.gorski+openwrt@gmail.com>
SVN-Revision: 24185
2010-11-28 22:04:19 +00:00
a133b09b07
refresh patches and remove trailing whitespaces
...
SVN-Revision: 24181
2010-11-28 18:14:34 +00:00
27189b328e
refresh and refine 972-cpmac_multi_probe.patch, patch from sn9
...
SVN-Revision: 24180
2010-11-28 18:03:56 +00:00
629cc5b101
refresh 973-cpmac_handle_mvswitch.patch
...
SVN-Revision: 24179
2010-11-28 18:03:48 +00:00
a2aa5a227e
refresh and refine vlynq patch, patch from sn9
...
SVN-Revision: 24178
2010-11-28 18:03:42 +00:00
af2349b4bc
brcm47xx: remove support for old kernel versions
...
SVN-Revision: 24168
2010-11-28 14:08:04 +00:00
6f58cc20fc
brcm47xx: use kernel 2.6.36.1 as new default kernel for this target.
...
SVN-Revision: 24167
2010-11-28 14:05:31 +00:00
34d53c2be1
kernel: add missing config symbols for 2.6.37-rc3
...
Thank you maddes for reporting. (closes #8323 )
SVN-Revision: 24165
2010-11-28 11:14:25 +00:00
fb27da9487
brcm47xx: reorder patches like they were commitet upstream
...
SVN-Revision: 24162
2010-11-27 22:47:11 +00:00
b54002aa8e
remove CONFIG_ADM6996_PHY=y for ar7 and atheros - this driver is incomplete and should not be used yet
...
SVN-Revision: 24161
2010-11-27 22:40:26 +00:00
256f94dea4
kernel: add missing config option
...
SVN-Revision: 24157
2010-11-27 16:08:41 +00:00
Gabor Juhos
Imre Kaloz
Daniel Dickinson
Hauke Mehrtens
Felix Fietkau
Jo-Philipp Wich
Florian Fainelli