The conversion was not 100% correct and leads to u-boot failing to
verify the CRC, revert that change for now.
Signed-off-by: Florian Fainelli <florian@openwrt.org>
SVN-Revision: 42170
The change is the same as ("kernel/generic: modify mtd related
patches"). Since these files are under files directory, not a files
directory of specific kernel version, better to also change them. So
it will avoid adding files to future specific files directory
(e.g. files-3.14) for this mtd related change.
Signed-off-by: Zhao, Gang <gamerh2o@gmail.com>
SVN-Revision: 40732
Isolate the PCI specific parts and group them under CONFIG_TULIP_PCI
CONFIG_TULIP_PLATFORM can be enabled for a platform style Tulip driver.
Signed-off-by: Florian Fainelli <florian@openwrt.org>
SVN-Revision: 34557
At some point we should make the ADM5120 PCI controller driver a real
platform driver and share that one between the two targets.
Signed-off-by: Florian Fainelli <florian@openwrt.org>
SVN-Revision: 34553
This is not the place to expose it and duplicates code reading the
system frequency.
Signed-off-by: Florian Fainelli <florian@openwrt.org>
SVN-Revision: 34551
my-mkimage previously did not include the fs_mark of deadc0de because
upon formatting of jffs2 partition, U-Boot's CRC validation would not
allow the image to boot. This new MTD map will shrink the
kernel+rootfs+fs_mark image and recalculate the CRC, so that only the
kernel is part of the image validation. This also improves boot time,
since less is copied from FLASH->RAM. This is mostly from brcm47xx,
just with u-boot image vs TRX partitions.
Signed-off-by: Scott Nicholas <scott.nicholas@scottn.us>
SVN-Revision: 25176
This patch cleans up the include directory, as they were from vendors
2.4 GPL source. Now only what's used is there.
Signed-off-by: Scott Nicholas <scott.nicholas@scottn.us>
SVN-Revision: 25175
Florian Fainelli
Hauke Mehrtens
Gabor Juhos